SF2008D Datasheet, PDF (1/4 Pages) RF Monolithics, Inc – 930.5 MHz SAW Filter

• RF Filter for Pager Applications
• High Rejection Out of Band
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage Between Any Two Terminals
Storage Temperature Range in Tape and Reel
Suitable for Lead-free Soldering - Maximum Soldering Profile
Pb
Value
Units
0
dBm
30
VDC
-40 to +85
°C
260 °C for 30 s
SF2008D
930.5 MHz
SAW Filter
Electrical Characteristics
Characteristic
Center Frequency
Passband Insertion Loss, 928.5 to 932.5 MHz
Passband Amplitude Ripple, 928.5 to 932.5 MHz
Rejection Referenced to IL_MAX
400 to 880 MHz
884.8 to 890.2 MHz
906.8 to 911.2 MHz
980 to 1300 MHz
Operating Temperature Range
Input Impedance at f_C
Output Impedance at f_C
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity Reel Size 7 Inch
Reel Size 13 Inch
Electrical Connections
Connection
Port 1
Port 2
Case Ground
Terminals
2
5
All others
Sym Notes
Min
f_C
1
IL_MAX
1, 2
Typ
930.5
SM3838-6
Max
4.5
2.0
Units
MHz
dB
dB_P-P
1, 2, 3
T_A
1
35
40
30
35
-20
50 - j57 ohm
50 - j57 ohm
dB
+70
°C
SM3838-6 3.8 x 3.8 mm Nominal Footprint
455, YWWS
1000 Pieces/Reel
3000 Pieces/Reel
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating tem-
perature range with filter soldered to the specified demonstration board
with impedance matching to 50 Ω and measured with 50 Ω network ana-
lyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are
subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
www.RFM.com E-mail: [e-mail]
©2013 by RF Monolithics, Inc.
Page 1 of 4
SF2008D - 7/29/13