SF2006C Datasheet, PDF (1/4 Pages) RF Monolithics, Inc – 190.00 MHz SAW Filter

• SAW Filter for W-CDMA
• 5.0 X 5.0 X 1.7 mm Surface-Mount Case
• Complies with Directive 2002/95/EC (RoHS) _Pb
Maximum Rating
Rating
Input Power Level
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Value
10
-30 to +70
-30 to +70
Units
dBm
°C
°C
SF2006C
190.00 MHz
SAW Filter
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss
6 dB Bandwidth
Group Delay Ripple
RMS Phase Linearity, f_C ± 2 MHz
Attenuation Referended to IL_MIN:
170 to 180 MHz, or (f_C - 20 MHz) to (f_C - 10 MHz)
180 to 185.5 MHz, or (f_C -10 MHz) to (f_C -4.5 MHz)
194.5 to 200 MHz, or (f_C + 4.5 MHz) to (f_C + 10 MHz)
200 to 210 MHz, or (f_C + 10 MHz) to (f_C + 20 MHz)
Ultimate Rejection
Lid Symbolization (Y=year, WW=week, S=shift)
Electrical Connections
Connection
Port 1
Input
Port 2
Output
Ground
Dot indicates Pin 1
Terminals
2
6
All others
Sym
f_C
IL_MIN
BW
Notes
SM5050-8
Min
Typ
Max
190
8.0
10
4.8
5.73
70
150
6
8
27
34
25
31
25
30
27
33
50
RFM 734 YWWS
Units
MHz
dB
MHz
ns
deg
dB
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temper-
ature range with filter soldered to the specified demonstration board with
impedance matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the
nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the
passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42
for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production"
and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are
subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design.
However, impedances and impedance matching may vary between Port 1
and Port 2, so that the filter must always be installed in one direction per
the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered
trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: [e-mail]
©2008-2010 by RF Monolithics, Inc.
Page 1 of 4
SF2006C - 6/14/10