|
LQH44PN100MP0L Datasheet, PDF (1/2 Pages) Murata Manufacturing Co., Ltd. – Chip Inductor (Chip Coil) Power Inductor (Wire Wound Type) | |||
|
Inductors (Coils) > Chip Inductor (Chip Coil) > Power Inductor (Wire Wound Type)
Data Sheet
1
Chip Inductor (Chip Coil) Power Inductor (Wire Wound Type)
LQH44P_P0 Series (1515 Size)
c Dimensions
c Packaging
Code
Packaging
L
180mm Embossed Tape
K
330mm Embossed Tape
Minimum Quantity
1000
3500
4.0±0.2
1.2±0.2 1.2±0.2
(in mm)
c Rated Value (p: packaging code)
Part Number
Inductance
Rated Current
Rated Current
(Based on Inductance Change) (Based on Temperature Rise)
LQH44PN1R0NP0p 1.0µH ±30%
2950mA
LQH44PN2R2MP0p 2.2µH ±20%
2500mA
LQH44PN3R3MP0p 3.3µH ±20%
2100mA
LQH44PN4R7MP0p 4.7µH ±20%
1700mA
LQH44PN6R8MP0p 6.8µH ±20%
1400mA
LQH44PN100MP0p
10µH ±20%
1150mA
LQH44PN220MP0p
22µH ±20%
800mA
Test Frequency: 1MHz Class of Magnetic Shield: Magnetic shield of magnetic powder in resin
Operating Temperature Range (Self-temperature rise is included): -40 to +125°C
Operating Temperature Range (Self-temperature rise is not included): -40 to +85°C
Only for reï¬ow soldering.
2450mA
1800mA
1770mA
1700mA
1340mA
1170mA
790mA
DC Resistance
0.030ohm ±20%
0.049ohm ±20%
0.065ohm ±20%
0.080ohm ±20%
0.12ohm ±20%
0.16ohm ±20%
0.37ohm ±20%
Self Resonance
Frequency (min.)
90MHz
70MHz
50MHz
40MHz
35MHz
25MHz
17MHz
c Notice (Rated Current)
When Rated Current is applied to the Products,
Inductance will be within ±30% of nominal
Inductance value.
When Rated Current is applied to the Products,
self-generation of heat will rise to 40°C or less.
Continued on the following page.
oThis data sheet is applied for CHIP INDUCTORS (CHIP COILS) used for General Electronics equipment for your design.
!Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, itâs speciï¬cations are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical speciï¬cations because there is no space for detailed speciï¬cations. Therefore, please approve our product
speciï¬cations or transact the approval sheet for product speciï¬cations before ordering.
2012.3.1
http://www.murata.com/
|
▷ |