LEN-D12 Datasheet, PDF (1/10 Pages) Murata Manufacturing Co., Ltd. – Non-Isolated 28A Eighth Brick DC/DC Converters

LEN-D12 Models
Non-Isolated, 28A Eighth Brick
DC/DC Converters
Typical Units
Non Isolated, 12VIN, 0.8-5VOUT
28 Amp DC/DC Converters
FEATURES
Eighth brick, through hole or SMT
2-phase buck regulators for new
distributed 12V power architectures
12V input (10.2-13.8V range)
0.8-2.5VOUT, 3.3VOUT @ 28A, 5VOUT @ 25A
Non-isolated, fixed-frequency
Synchronous-rectifier topology
Efficiencies to 95% @ 25 Amps
Noise as low as 25mVp-p
Stable no-load operation
On/Off control, trim & sense functions
Input Over/Undervoltage lockout
Thermal shutdown
Designed to meet UL/EN/IEC60950-1
EMC compliant
Ḥ
PRODUCT OVERVIEW
The LEN D12 Series of non-isolated eighth
bricks are ideal building blocks for emerg-
ing, on-board power-distribution schemes
in which isolated 12V buses deliver power
to any number of non-isolated, step-down
buck regulators. LEN D12 DC/DCs accept a
12V input (10.2V to 13.8V input range) and
convert it, with the highest efficiency in the
smallest space, to a 0.8, 1, 1.2, 1.5, 1.8, 2,
2.5, or 3.3 Volt output fully rated at 28 Amps,
or 5 Volt output at 25 Amps.
LEN D12s are ideal POLPP's (point-of-use/
load power processors) and they typically re-
quire no external components. They occupy the
standard eighth-brick board space (0.9" x 2.3")
and come in either through-hole packages or
surface-mount packages with a profile of only
0.46" (0.5" including optional heat sink).
The LEN's best-in-class power density is
achieved with a fully synchronous,fixed-
frequency, 2-phase buck topology that deliv-
ers extremely high efficiency (95% for 5VOUT
models), low noise (25mVp-p typ.), tight
line/load regulation (±0.25% max.), quick
step response (150μsec), stable no-load
operation, and no output reverse conduction.
The fully functional LEN's feature input
over/undervoltage lockout, output overvolt-
age and overcurrent detection, continuous
short-circuit protection, overtemperature
protection, an output-voltage trim function,
a remote on/off control pin, and a sense pin.
High efficiency enables the LEN D12s to
deliver rated output currents of 25 Amps at
ambient temperatures to +65°C with 200 lfm
air flow without heat sink.
If your new system boards call for multiple
supply voltages, check out the economics of
on-board 12V distributed power. If you don't
need to pay for multiple isolation barriers,
MPS’s non-isolated ¼ and ¹âˆ•8 brick’s will save
you money.
For full details go to
www.murata-ps.com/rohs
+INPUT
(5)
~
COMMON
(1)
ON/OFF
CONTROL
(4)
CURRENT
SENSE
VCC
2-PHASE
PWM
CONTROLLER
Figure 1. Simplified Schematic
www.murata-ps.com
Typical topology is shown
+OUTPUT
(7,9)
+SENSE
(10)
COMMON
(6, 8)
REFERENCE &
ERROR AMP
~Only one phase of two shown.
VOUT
TRIM
(2)
Technical enquiries email: [e-mail], tel: [phone]
MDC_LEN D12 Models.B01 Page 1 of 10