D1U4-W-1600-12-HC2C Datasheet, PDF (2/5 Pages) Murata Power Solutions Inc. – AC/DC Front End Power Supply

OUTPUT CHARACTERISTICS
Parameter
Remote Sense
Efficiency
Output Rise Monotonicity
Start-up Time
Transient Response
Current sharing accuracy (up to 3 in parallel)
Hot Swap Transients
Hold-up Time
GENERAL CHARACTERISTICS
Parameter
Storage Temperature Range
Operating Temperature Range
Operating Humidity
Storage Humidity
Shock
Sinusoidal Vibration
MTBF
Acoustic
Safety Approvals
Input Fuse
Material Flammability
Switching Frequency
Weight
PROTECTION CHARACTERISTICS
Output
Voltage
Parameter
Over-temperature
Over Voltage
12V
Over Current
3.3Vsb
Over Voltage
Over Current
Over Voltage
5Vsb
Over Current
ISOLATION CHARACTERISTICS
Parameter
Insulation Safety Rating / Test Voltage
Isolation
Material Flammability
Grounding
www.murata-ps.com
D1U4-W-1600-12-Hx Series
AC/DC Front End Power Supply
Conditions
Min.
Typ.
Max.
Units
120
mV
220Vac
90.6
%
Overshoot less than 10% for all outputs, no voltage negative between 10% to 95% during ramp up
AC ramp up
1.5
s
PS_On activated
150
ms
12V Ramp 1A/ms
±600
3.3Vsb Ramp 1A/ms
±165
mV
5Vsb Ramp 1A/ms
±250
At 100% load
±10
%
All outputs within regulation
20
ms
Conditions
Min.
Typ.
Max.
Units
Non-condensing
-40
70
°C
0
50
Non-condensing
10
90
%
5
90
30G non operating
0.5G, 5 – 500 Hz operating
Calculated per Bellcore at Ta=30°C
200
Khrs
Demonstrated
200
Khrs
ISO 7779-1999
60
dB LpAm
c-CSA-us (CSA 60950-1-03/UL 60950-1, First Edition) TUV approval (Bauart) EN 60950-1:2001
Power Supply has internal 20A/250V fast blow fuse on the AC line input
UL 94V-0
90KHz for Boost PFC Converter
165KHz for Main Output Converter
200KHz for Standby Output Converter
2.1kg
Conditions
Auto-restart
Latching
Latching
Latching
Latching
Latching
Latching
Min.
Typ.
Max.
Units
55
65
°C
13
14
V
145
165
A
3.57
4.02
V
6.5
8
A
5.6
6
V
5
7
A
Conditions
Input to Output - Reinforced
Input to Chassis - Basic
Output to Chassis
Output to Output
UL 94V-0
Min.
Typ.
Max.
Units
3000
Vrms
1500
Vrms
Main Output Return and Standby Output Return are connected internally. 100kΩ resistor parallel with 100nF
capacitor is connected between Return and power supply chassis. Main Output Return should be connected
to the System Chassis
Technical enquiries email: [e-mail], tel: [phone]
CPS_D1U4-1600-12-Hx.A02 Page 2 of 5