MYGTM01210BZN Datasheet, PDF (11/17 Pages) Murata Power Solutions Inc. – DC-DC Converter Application Manual

MYGTM01210BZN Application
11
11. Notice
11.1 Soldering
11.1.1 Flux
Please solder the products with no-cleaning type Rosin Flux which leaves little residue and low
activity . Do not use cleaning type flax, in case that you wash the products after using cleaning
type flux, they may damage mounting parts on the products and may cause defective or low
quality products.
11. 1.2 Solder
Please recommend use of the solder Sn-3Ag-0.5Cu.
When use other solders, use it after examining at customer.
11. 1.3 Condition of soldering
Please solder under the following condition.
ï½¥ Flow soldering Preheating
Soldering
: 120±10 ^oC 60～120 seconds
: 255±5 ^oC
Time within
: 10 seconds
ï½¥ Condition of iron soldering
: under 380 ^oC, 4 seconds at maximum
(Only iron less than 30W should be used.)
11. 2 Cleaning
Please do not wash the products.
Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’ s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
2010.7.14