|
XF9430R Datasheet, PDF (1/1 Pages) MTRONPTI – Specification for a Monolithic SMD Crystal Filter | |||
|
Specification for a Monolithic SMD Crystal Filter
MtronPTI P/N: XF9430R
I. General & Electrical Requirements:
1. Center Frequency (FON): 75.75MHz
2. Passband:
@ 1dB: ï³ FON ï±7.5kHz
@ 3dB: ï³ FON ï±10.0kHz
3. Insertion Loss (@ peak of transmission within the 3dB passband): ⤠4.0dB
4. Passband Ripple (peak-valley): ⤠1.0dB
5. Stopband Attenuation
> 45dB: FON ï±40.0kHz (absolute)
> 70dB: FON ï±910.0kHz
6. Group Delay Variation (within FON ï±7.5kHz): 15µsec
7. Input 3rd Order Intercept Point: > +30dBm
Input Frequency: FON ±50kHz and FON ±100kHz
Input Signal Level: -10dBm to -20dBm
8. Input Signal:
Operating (full specification compliance): -5dBm nominal
Peak (No Damage): +15dBm
9. Input/Output Terminating Impedance (ZIN/ZOUT): 50Ω nominal
Note 1: All electrical performance specifications are valid over the full Operating Temperature Range (-30ËC to +75ËC) unless otherwise noted.
Note 2: All electrical performance specifications are to be validated and adjusted at the prototype build stage.
II. Environmental, Physical & Reflow Requirements:
1. Temperature Range
Operating: -30ï°C to +75ï°C
Storage: -40ï°C to +85ï°C
2. Solderability: Per EIAJ-STD-002
3. Package: SMD (ref Figure 1)
4. RoHS Compliant
Figure 1 â Filter Package Outline Drawing
Figure 2 â Recommended Reflow Profile
Rev. - 03/14/13
Page 1 of 1
The information contained herein is proprietary to MtronPTI and is submitted in confidence.
This information may not be copied or divulged without the express written permission of MtronPTI
|