LF9395 Datasheet, PDF(1/2 Page) MTRONPTI – Specification for an SMD LC Filter

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

LF9395 Datasheet, PDF (1/2 Pages) MTRONPTI – Specification for an SMD LC Filter

Specification for an SMD LC Filter

MtronPTI P/N: LF9395

I. General & Electrical Requirements

1. Center Frequency (FON): 45.0MHz ï±0.5MHz

2. Passband @ 3dB: â¤ FON ï±3.75MHz

3. Insertion Loss (@FON): â¤ 2dB

4. Insertion Loss Ripple (peak-valley, FON ï±2.0MHz): â¤ 0.2dB

5. Input/Output VSWR (Ref to 50Î©, over FON ï±2.0MHz): â¤ 1.5:1

6. Phase Offset @ FON and @ 25ï°C: â¤ ï±7ï°

7. Phase Tracking FON ï±1.5MHz: â¤ ï±4ï°, after subtraction of ï±7ï° (max) Phase Offset at FON @ 25ï°C

8. Amplitude Offset @ FON and @ 25ï°C: â¤ ï±0.5dB

9. Amplitude Tracking FON ï±1.5MHz: â¤ ï±0.5dB, after subtraction of ï±0.5dB (max) Amplitude Offset at FON @ 25ï°C

10. Rejection (Minimum, Relative to Insertion Loss) (all to be validated at prototype build)

90dBc: 0Hz to 5MHz

60dBc: 5MHz to 15MHz

60dBc: 130MHz to 360MHz

90dBc: 360MHz to 1000MHz

11. Signal Level: +20dBm (CW) with a 2:1 load

12. ZS/ZL: 50Î© nominal

II. Environmental & Physical Requirements:

1. Temperature Range

Operating: -40ï°C to +71ï°C

Storage: -65ï°C to +150ï°C

2. Solderability: Per EIAJ-STD-002

3. Package (see Figure 1):

Size: 1.00â (L) x 0.375â (W) x 0.3â (H) (1.25â max length id 4-pole is required)

Seal: Hermetic, laser sealed

Finish: Nickel Plated Body, Sn63Pb37 (or equivalent) tinned terminals

4. Delivery shall be a matched set of 6-filters

Part markings shall identify sets.

Rev. - 05/24/12

Page 1 of 2

The information contained herein is proprietary to MtronPTI and is submitted in confidence.

This information may not be copied or divulged without the express written permission of MtronPTI

▷