LF9348 Datasheet, PDF (1/1 Pages) MTRONPTI – Specification for a Bandpass LC Filter

Specification for a Bandpass LC Filter
MtronPTI P/N: LF9348
I. General & Electrical Requirements:
Center Frequency (F_ON): 10.0MHz
Bandwidth @ 3dB: ≥ 1.0MHz
Insertion Loss (at the peak of transmission within the 3dB bandwidth): ≤ 3.0dB
Rejection (minimum, ref. to IL):
30dB: F_ON ±2MHz maximum
Z_IN/Z_OUT: 50Ω nominal
Note: Sn10 high temperature solder is utilized in the construction of this filter in support of automated assembly & reflow processing.
II. Environmental & Physical Requirements:
1. Temperature Ranges
Operating (OTR): -40C to +85C
Storage (STR): -45C to +90C
2. Per EIAJ Per EIAJ-STD-002
3. Seal: Waterproof, supports post-reflow aqueous/non-aqueous wash
4. Package: (reference drawing)
5. Tape & Reel Available: 100-units/reel minimum
6. Package: (reference drawing)
Package Outline Drawing
Recommended PAD Layout
Recommended Reflow Soldering Profile
Rev. - 07/28/11
Page 1 of 1
Proprietary Document Information contained herein is proprietary to MtronPTI and is
submitted in confidence. Information may not be copied or divulged without written
permission from MtronPTI.