|
4133SMD Datasheet, PDF (1/1 Pages) MTRONPTI – Crystal Front-End-Filter | |||
|
MtronPTI 4-Pole 4133SMD Series
Crystal Front-End-Filter
I. General & Electrical Requirements:
1. Center Frequency (FON): 25MHz to 200MHz
2. Passband @ 3dB: FON ï±6.75kHz
3. Insertion Loss (@ peak of transmission within the 3dB passband):
For FON of 25.00MHz thru 35.99MHz: ⤠5.0dB
For FON of 36.00MHz thru 137.99MHz: ⤠6.0dB
For FON of 138.00MHz thru 200.00MHz: ⤠7.0dB
4. Stopband Attenuation
20dB minimum
For FON of 25.00MHz thru 89.99MHz: FON ï±26.0kHz
For FON of 90.00MHz thru 200.00MHz: FON ï±30.0kHz
40dB minimum for FON of 25.00MHz thru 200.00MHz: FON ï±50.0kH
5. Input Signal: 0dBm maximum
6. Input/Output Terminating Impedance (ZIN/ZOUT): 50Ω nominal
Note 1: All electrical performance specifications are valid over the full Operating Temperature Range (-20ËC to +70ËC) unless otherwise noted.
II. Environmental, Physical & Reflow Requirements:
1. Temperature Range
Operating: -20ï°C to +70ï°C
Storage: -40ï°C to +85ï°C
2. Solderability: Per EIAJ-STD-002 See Note 2
3. Package: SMD (ref Figure 1) See Note 2
Note 2: Although the 4133SMD Series are SMD devices, they are not reflowable assembly compatible devices.
Therefore, they must be hand assembled to the PCB with a maximum land temperature of +260ËC for < 3seconds.
Figure 1 â Filter Package Outline Drawing
Note 3: The order code example for a 102.175MHz 4133SMD would be as follows: 4133SMD @ 102.175MHz.
Rev. A 04/12/13
Page 1 of 1
The information contained herein is proprietary to MtronPTI and is submitted in confidence.
This information may not be copied or divulged without the express written permission of MtronPTI
|