MSK4851H Datasheet, PDF (1/5 Pages) M.S. Kennedy Corporation – 600V/200A THREE PHASE BRIDGE PEM WITH BRAKE

ISO-9001 CERTIFIED BY DSCC
600V/200A
4851 ^{THREE PHASE BRIDGE}
M.S.KENNEDY CORP. PEM WITH BRAKE
4707 Dey Road Liverpool, N.Y. 13088
[phone]
FEATURES:
Full Three Phase Bridge Configuration with SCR/IGBT Brake
600V Rated Voltage
200A Continuous Output Current
Internal Zener Clamps on Gates
Proprietary Encapsulation Provides Near Hermetic Performance
MIL-PRF-38534 Screening Available (Modified)
Light Weight Domed ALSIC Baseplate
Robust Mechanical Design for Hi-Rel Applications
Ultra-Low Inductance Internal Layout
Withstands 96 Hours HAST and Thermal Cycling (-55°C to +125°C)
MIL-PRF-38534 CERTIFIED
DESCRIPTION:
The MSK 4851 is one of a family of plastic encapsulated modules (PEM) developed specifically for use in military,
aerospace and other severe environment applications. The Three Phase Bridge configuration along with the SCR/IGBT
brake circuit and 600 volt/200 amp rating make it ideal for use in high current motor drive and inverter applications. The
Aluminum Silicon Carbide (AlSiC) baseplate offers superior flatness and light weight; far better than the copper or copper
alloys found in most high power plastic modules. The high thermal conductivity materials used to construct the MSK 4851
allow high power outputs at elevated baseplate temperatures. Our proprietary coating, SEES™ - Severe Environment
Encapsulation System - protects the internal circuitry of MSK PEM's from moisture and contamination, allowing them to
pass the rugged environmental screening requirements of military and aerospace applications. MSK PEM's are also avail-
able with industry standard silicone gel coatings for a lower cost option.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
Motor Drives
Inverters
1
Rev. B 8/05