MSK4801H Datasheet, PDF (1/6 Pages) M.S. Kennedy Corporation – 600V/600A HALF BRIDGE PEM

ISO-9001 CERTIFIED BY DSCC
600V/600A
HALF BRIDGE PEM
M.S.KENNEDY CORP.
4707 Dey Road Liverpool, N.Y. 13088
4801
[phone]
FEATURES:
Half Bridge Configuration
600V Rated Voltage
600A Continuous Output Current
Internal Zener Clamps on Gates
Proprietary Encapsulation Provides Near Hermetic Performance
MIL-PRF-38534 Screening Available (Modified)
Light Weight Ultra-Flat AlSiC Baseplate
Robust Mechanical Design for Hi-Rel Applications
Ultra-Low Inductance Internal Layout
Withstands HAST and Thermal Cycling (-55°C to +125°C)
High Side Collector Sense Pin for De-Sat Detection
MIL-PRF-38534 CERTIFIED
DESCRIPTION:
The MSK 4801 is one of a family of Plastic Encapsulated Modules (PEM) developed specifically for use in military,
aerospace and other severe environment applications. The half bridge configuration and 600 volt/600 amp rating make it
ideal for use in high current motor drive and inverter applications. The Aluminum Silicon Carbide (AlSiC) baseplate offers
superior flatness and light weight; far better than the copper or copper alloys found in most high power plastic modules.
The high thermal conductivity materials used to construct the MSK 4801 allow high power outputs at elevated baseplate
temperatures. Our proprietary coating, SEES™ - Severe Environment Encapsulation System - protects the internal circuitry
of MSK PEM's from moisture and contamination, allowing them to pass the rugged environmental screening requirements
of military and aerospace applications. MSK PEM's are also available with industry standard silicone gel coatings for a
lower cost option.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
Motor Drives
Inverters
1
PRELIMINARY Rev. - 11/03