MSK4363 Datasheet, PDF (1/7 Pages) M.S. Kennedy Corporation – 10 AMP, 75V, 3 PHASE MOSFET BRUSHLESS MOTOR CONTROLLER

MIL-PRF-38534 & 38535 CERTIFIED FACILITY
M.S.KENNEDY CORP.
10 AMP, 75V, 3 PHASE
MOSFET BRUSHLESS
MOTOR CONTROLLER
4363
4707 Dey Road Liverpool, N.Y. 13088
[phone]
FEATURES:
75 Volt Motor Supply Voltage
10 Amp Output Switch Capability
100% Duty Cycle High Side Conduction Capable
Shoot-Through/Cross Conduction Protection
Hall Sensing and Commutation Circuitry on Board
"Real" Four Quadrant Torque Control Capability
Good Accuracy Around the Null Torque Point
Isolated Base Plate Design for High Voltage Isolation Plus Good Thermal Transfer
60°/ 120º Phasing Selectable
Contact MSK for MIL-PRF-38534 Qualification Status
DESCRIPTION:
The MSK 4363 is a complete 3 Phase MOSFET Bridge Brushless Motor Control System in an electrically isolated
hermetic package. The hybrid is capable of 10 amps of output current and 75 volts of DC bus voltage. It has the
normal features for protecting the bridge. Included is all the bridge drive circuitry, hall sensing circuitry, commutation
circuitry and all the current sensing and analog circuitry necessary for closed loop current mode (torque) control.
When PWM'ing, the transistors are modulated in locked anti-phase mode for the tightest control and the most
bandwidth. Provisions for applying different compensation schemes are included. The MSK 4363 has good thermal
conductivity of the MOSFET's due to isolated substrate/package design that allows direct heat sinking of the hybrid
without insulators.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
3 Phase Brushless DC Motor Control
Servo Control
Fin Actuator Control
Gimbal Control
AZ-EL Control
1
8548-106 Rev. P 10/13