MSK4250_15 Datasheet, PDF (1/6 Pages) M.S. Kennedy Corporation – 75 Volt Motor Supply Voltage

MIL-PRF-38534 CERTIFIED FACILITY
M.S.KENNEDY CORP.
10 AMP, 75V, H-BRIDGE
MOSFET BRUSHED
MOTOR CONTROLLER
4707 Dey Road Liverpool, N.Y. 13088
4250
[phone]
FEATURES:
75 Volt Motor Supply Voltage
10 Amp Output Switch Capability
100% Duty Cycle High Side Conduction Capable
Shoot-Through/Cross Conduction Protection
"Real" Four Quadrant Torque Control Capability
Good Accuracy Around the Null Torque Point
Contact MSK for MIL-PRF-38535 Qualification Status
DESCRIPTION:
The MSK 4250 is a complete H-bridge MOSFET Brushed Motor Control System in an electrically isolated hermetic
package. The hybrid is capable of 10 amps of output current and 75 volts of DC bus voltage. It has the normal
features for protecting the bridge. Included is all the bridge drive circuitry, and all the current sensing and analog
circuitry necessary for closed loop current mode (torque) control. When PWM'ing, the transistors are modulated in
locked anti-phase mode for the tightest control and the most bandwidth. Provisions for applying different compensa-
tion schemes are included. The MSK 4250 has good thermal conductivity of the MOSFET's due to isolated substrate/
package design that allows direct heat sinking of the hybrid without insulators.
EQUIVALENT SCHEMATIC
TYPICAL APPLICATIONS
Brushed DC Motor Control
Servo Control
Fin Actuator Control
Voice Coil Control
Gimbal Control
AZ-EL Control
1
Rev. G 3/11