SFP-10GD-SX Datasheet, PDF (1/5 Pages) MRV Communications, Inc. – 10 Gbps 850 nm Multi-mode SFP+ Transceiver

Datasheet
10 Gbps 850 nm Multi-mode SFP+ Transceiver
SFP-10GD-SX
Features
Hot-pluggable SFP+ footprint
Supports 9.95 to 10.52 Gbps bit rates
Power dissipation < 1W
RoHS-6 compliant (lead-free)
Commercial temperature range 0°C to 70°C
Single 3.3 V power supply
Maximum link length of 300 m on 2000 MHZ-km MMF
Uncooled 850 nm VCSEL laser
Receiver limiting electrical interface
Duplex LC connector
Built-in digital diagnostic functions
MRV’s SFP-10GD-SX 10Gbps SFP+ transceivers are designed for use in 10-Gigabit Ethernet and 10-Gigabit Fibre Channel links over
multi-mode fiber. They are compliant with SFF-8431, SFF-8432, and IEEE 802.3ae 10GBASE-SR. Digital Diagnostics functions are
available through a 2-wire serial interface, as specified in SFF-8472. The transceiver is RoHS compliant and lead free as defined in Directive
2002/95/EC.
Absolute Maximum Ratings*
Parameter
Maximum Supply Voltage
Case Operating Temperature
Storage Temperature
Relative Humidity (Non-Condensing)
Symbol
Vcc
TA
TS
RH
Minimum
-0.5
0
-40
0
Typical
-
-
-
-
Maximum
4.0
70
85
85
Unit
Note
V
-
ºC
-
ºC
-
%
-
*Exceeding the limits listed in the table may damage the transceiver module permanently
Electrical Specifications
Parameter
Supply Voltage
Supply Current
Transmitter
Input Differential Impedance
Single Ended Data Input Swing
Transmit Disable Voltage
Transmit Enable Voltage
Receiver
Single Ended Data Output Swing
Data Output Rise Time, Fall Time
LOS Fault
LOS Normal
Power Supply Noise Tolerance
Symbol
Vcc
Icc
R_in
V in, pp
V_D
V_EN
V out, pp
t_r, t_f
V_{LOS fault}
V_{LOS norm}
VccT/ VccR
Minimum
3.14
-
Typical
-
-
Maximum
3.46
250
-
100
-
180
-
700
2
-
Vcc
Vee
-
Vee+0.8
300
-
850
28
-
-
2
-
Vcc_HOST
Vee
-
Vee+0.8
Per SFF-8431 Rev 2.1
Unit
V
mA
Ω
mV
V
V
mV
ps
V
V
mVpp
Note
-
-
1
-
-
-
2
3
4
4
5
Notes: 1.
2.
3.
4.
5.
Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
Into 100Ω differential termination.
20 – 80 % . Measured with Module Compliance Test Board and OMA test pattern. Use of four 1’s and four 0’s in sequence in the
PRBS^9 is an acceptable alternative. SFF-8431 Rev 2.1
LOS is an open collector output. Should be pulled up with 4.7kΩ – 10kΩ on the host board. Normal operation is logic 0; loss of
signal is logic 1. Maximum pull-up voltage is 5.5V.
Testing methodology per SFF-8431. Rev 2.1
1