EM1600-8CC10G Datasheet, PDF (1/2 Pages) MRV Communications, Inc. – LambdaDriver 10Gbps 8 ports XFP - EXC Module (EM1600-8CC10G)

WDM & Optical Transport
Datasheet
LambdaDriver^® –10Gbps 8 ports XFP - EXC Module (EM1600-8CC10G)
Features
Front panel user interfaces with port status indicators
XFPs provide SFF-8472 digital diagnostics support
LIN support
XFP ports settable to full-duplex 10Gbps Ethernet
or OC-192 per module
Flexible port cross-connectivity
Installable in LD1600, 1600L or LD400L chassis
1-Long slot
Hot-swappable
Overview
Applications
The LD1600-8CC10G module can be used as a 10GE
or OC192 quad transponder or as Electrical ROADM
for 2 x 10 Gbps DWDM channels.
The EM1600-8CC10G XFP Dual Transponder module is a LIN notifies terminal equipment of link failure by cutting
single slot module that incorporates 8 independent
off laser power on the access side whenever no power is
XFP based 10 Gbps ports with intelligent port received from the WDM side, and vice versa.
interconnection functionality.
Loopback is used to test the integrity of the data path of
The flexible configuration options permit pairing
an individual port and its internal circuitry by returning
any-to-any port to provide several data transfer modes:
the received data to the transmitting device at the tested
interface.
- As 2 wavelengths Electrical ROADM
- Between flexibly selectable pairs of ports, i.e., in quad
As part of the LambdaDriver Optical Transport System the
transponder mode
LD1600-8CC10G can be managed via the management
- From one port to a third port in case the second port
module installed in the LambdaDriver either locally by
fails, i.e. in port protection mode
Serial/RS-232 connection or remotely by TELNET or SNMP.
Per-port front panel LEDs indicate XFP and link presence
The ports can be configured to operate under the
or absence.
10 Gbps Ethernet protocol or at the OC-192 data rate in
full-duplex mode with Link Integrity Notification (LIN) and
Loopback capability.
2 wave eROADM implementation
������������
������������
����
����
�������������
�������
�
�
�
�
�
�
�
�
����
����
����
����
�������������
�������
�
�
�
�
�
�
�
�
����
����
�� ���� ������
�����
�� ���� ������
�����
Two services dropped to site in port protection mode
�� ���� ������
�����
�� ���� ������
�����
Re-routing of service 1 to a different location
(pass-through) by remote configuration
Not sure what solution best fits your needs? Visit www.mrv.com or e-mail us at [e-mail]