EM1600-4CC10G Datasheet, PDF (1/2 Pages) MRV Communications, Inc. – LambdaDriver 10 Gbps XFP - Dual Transponder Module(EM1600-4CC10G)

WDM & Optical Transport
Datasheet
LambdaDriver^®–10 Gbps XFP - Dual Transponder Module (EM1600-4CC10G)
Features
Front panel user interfaces with port status indicators
XFPs provide SFF-8472 digital diagnostics support
LIN support
XFP ports settable to full-duplex 10Gbps Ethernet
or OC-192 per-module
Flexible port cross-connectivity
Installable in LD1600, 1600L or LD400L chassis
1-Long slot
Hot-swappable
Overview
The EM1600-4CC10G XFP Dual Transponder module is a
single slot module that incorporates 4 independent XFP
based 10 Gbps ports with intelligent port interconnection
functionality.
The flexible configuration options permit pairing any-
to-any port to form a dual 10 Gbps transponder in one
module.
An additional option is to use the module in a port
protection mode, in which case the traffic of one port is
normally forwarded to a second port defined as primary
port and in case of failure of the primary destination port
the traffic will be relayed to a second port defined as
secondary.
The ports can be configured to operate in the 10 Gbps
Ethernet protocol or at the OC-192 data rate in full-duplex
Applications
The EM1600-4CC10G module can be used as a 10GE
or OC192 dual transponder with integrated port
redundancy as an option and relay-to-LAN-Analyzer
capability.
mode with Link Integrity Notification (LIN) and LoopBack
capability.
LIN notifies terminal equipment of link failure by cutting
off laser power on the access side whenever no power is
received from the WDM side, and vice versa.
Loopback is used to test the integrity of the data path of
an individual port and its internal circuitry by returning the
received data back to the transmitting device at the tested
interface.
As part of the LambdaDriver Optical Transport System the
EM1600-4CC10G can be managed via the management
module installed in the LambdaDriver either locally via a
Serial/RS-232 connection or remotely via TELNET or SNMP.
Per-port front panel LEDs indicate XFP and link presence or
absence.
������
������
������
������
� ������� �
�������
�������������
Redundant Link Transponder
�������������
Dual Transponder
Not sure what solution best fits your needs? Visit www.mrv.com or e-mail us at [e-mail]