EVM3620A-QV-00A Datasheet, PDF (6/6 Pages) MPS Industries, Inc. – 24V/2A Module Converter with Integrated Inductor Evaluation Board

EVM3620A-QV-00A 24V/2A STEP-DOWN MODULE CONVERTER
QUICK START GUIDE
1. Connect the positive and negative terminals of the load to the V_OUT and GND pins, respectively.
2. Preset the power supply output between 4.5V and 24V, and then turn off the power supply.
3. Connect the positive and negative terminals of the power supply output to the V_IN and GND pins,
respectively.
4. Turn the power supply on. The board will automatically start up.
5. To use the Enable function, apply a digital input to the EN pin. Drive EN higher than 1.4V to turn
on the converter, or less than 1.25V to turn it off.
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EVM3620A-QV-00A Rev.1.0
www.MonolithicPower.com
6
9/25/2014
MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.
© 2014 MPS. All Rights Reserved.