SD01XXXR Datasheet, PDF (2/2 Pages) MPS Industries, Inc. – SD01XXXR SERIES

SD01XXXR SERIES
1W, Wide Input Range SIP, Single Output DC/DC Converters
Absolute Maximum Ratings
Parameter
Min. Max. Units
Lead Temperature
(1.5mm from case for 10sec.)
--- 260 °C
Exceeding the unit absolute maximum ratings could cause damage.
These are not continuous operating ratings.
General Characteristics
Parameter
Isolation
Voltage
Isolation
Resistance
Isolation
Capacitance
Conditions
60 Seconds
500VDC
100kHz, 1V
Switching
Frequency
MTBF
MIL-HDBK-217F
@25°C
Ground Benign
Min.
1000
10
---
50
1
Typ.
---
---
---
---
---
Max.
---
Units
VDC
---
GΩ
---
pF
---
kHz
---
MHrs
Environmental Characteristics
Output Characteristics
Parameter
Conditions
Min. Max. Units
Parameter
Conditions
Min. Typ. Max. Units
Operating
Temperature
Ambient
-40 85
°C
Line Regulation
For Vin Change of
1%
---
---
0.5
%
Operating
Temperature
Storage
Temperature
Humidity
Case
-25 90 °C
-50 130 °C
---
95
%
Load Regulation Io = 20% to 100% ---
Ripple & Noise
Ripple & Noise
20MHz BW
(5-9V)
---
20MHz BW
(12-15V)
---
---
0.8
%
---
100 mV P-P
---
150 mV P-P
Cooling
Free-Air Convection
Notes:
1. Specifications typical at Ta=+25°C, resistive load, nominal input
voltage, rated output current unless otherwise noted.
2. These power converters require a minimum output load to maintain
specified regulation.
3. Operation under no-load conditions will not damage these modules;
however, they may not meet all specifications listed.
4. All DC/DC converters should be externally fused at the front end for
protection.
5. Other input and output voltage may be available, please contact
factory.
6. All specifications subject to change without notice.
7. For detailed data sheet, please visit our website.
2463 208th Street, Ste. 205
Torrance, CA 90501
Tel: [phone]
Fax: [phone]
http://www.mpsind.com
E-mail: [e-mail]