MP29373 Datasheet, PDF (5/10 Pages) Monolithic Power Systems – Dual 1.5A, 23V, 1.4MHz Step-Down Converter

MP29373 — DUAL 1.5A, 23V, 1.4MHz STEP-DOWN CONVERTER
OPERATION
The MP29373 is a dual channel current mode
regulator. The COMP pin voltage is proportional
to the peak inductor current. At the beginning of
a cycle, the upper transistor M1 is off, and the
lower transistor M2 is on (see Figure 1). The
COMP pin voltage is higher than the current
sense amplifier output, and the current
comparator’s output is low. The rising edge of
the 1.4MHz CLK signal sets the RS Flip-Flop.
Its output turns off M2 and turns on M1 thus
connecting the SW pin and inductor to the input
supply. The increasing inductor current is
sensed and amplified by the Current Sense
Amplifier. Ramp compensation is summed to
Current Sense Amplifier output and compared
to the Error Amplifier output by the Current
Comparator.
When the sum of the Current Sense Amplifier
output and the Slope Compensation signal
exceeds the COMP pin voltage, the RS Flip-
Flop is reset. The MP29373 reverts to its initial
M1 off, M2 on state.
If the sum of the Current Sense Amplifier output
and the Slope Compensation signal does not
exceed the COMP voltage, the falling edge of
the CLK resets the Flip-Flop.
The output of the Error Amplifier integrates the
voltage difference between the feedback and
the 0.92V bandgap reference. The polarity is
such that a voltage at the FB pin lower than
0.92V increases the COMP pin voltage. Since
the COMP pin voltage is proportional to the
peak inductor current, an increase in its voltage
increases current delivered to the output. The
lower 10Ω switch ensures that the bootstrap
capacitor voltage is charged during light load
conditions. External Schottky Diode D1 carries
the inductor current when M1 is off (see Figure 1).
INA/
INB
ENA/
ENB
INTERNAL
REGULATORS
OSCILLATOR
SLOPE
COMP
210/1400KHz
CLK
+
0.7V --
--
SHUTDOWN
COMPARATOR
LOCKOUT
COMPARATOR
2.29V/
2.50V
+
+
--
CURRENT
SENSE
AMPLIFIER
+
--
+
SQ
RQ
--
CURRENT
COMPARATOR
1.8V
FREQUENCY
FOLDBACK
COMPARATOR
-- 0.4V
+
ERROR
AMPLIFIER
SGA/
SGB
FBA / FBB
Figure 1—Functional Block Diagram
(Diagram portrays ½ of the MP29373)
5V
BSA/
BSB
SWA/
SWB
COMPA/
COMPB
0.92V
SSA/
SSB
PGA/
PGB
MP29373 Rev. 1.1
www.MonolithicPower.com
5
12/13/2007
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2007 MPS. All Rights Reserved.