EV6001DN-00A Datasheet, PDF (5/5 Pages) Monolithic Power Systems – Monolithic Flyback/Forward DC-DC Converter Evaluation Board

TM
EV6001DN-00A – MONOLITHIC FLYBACK/FORWARD DC-DC CONVERTER EV BOARD
Figure 2—Bottom Layer
QUICK START GUIDE
1. Connect the positive terminal of the load to VOUT pin, and the negative terminal of the load to
GND pin.
2. Preset power supply output to 36V to 75V and turn off the power supply.
3. Connect the positive terminal of the power supply output to VIN pin, and the negative terminal of
the power supply output to GND pin.
4. Turn power supply on and the board will automatically startup.
5. To use Enable function, apply a digital input to EN pin. Drive EN with 2.5V-5V to turn on the
regulator, and drive EN less than 0.7V to turn it off.
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EV6001DN-00A Rev. 1.0
www.MonolithicPower.com
5
4/12/2006
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.