EV8802DJ-00A Datasheet, PDF (4/4 Pages) Monolithic Power Systems – Low Dropout 250mA Linear Regulator

EV8802DJ-00A — LOW DROPOUT 250mA LINEAR REGULATOR
EVALUATION BOARD
QUICK START GUIDE
The output voltage of this board is set to 2.5V. The EN pin is connected to VIN with a 10kΩ
resistor for automatic startup. You can connect EN to GND to disable the MP8802.
1. Attach the positive and the negative ends of the load to the VOUT and GND pins,
respectively.
2. Attach an input voltage (2.7V ≤ V_IN ≤ 6.5V) and input ground to the VIN and GND pins,
respectively.
3. The output voltage (V_OUT) can be changed by adding a resistor divider (R1 and R2). A
10kΩ (±1%) resistor should be used for the low-side resistor R2 of the voltage divider.
The high side resistor R1 can be determined by the equation:
R1
=
R2
×
⎜⎜⎝⎛
V_OUT −
V_FB
V_FB
⎟⎟⎠⎞
Where V_FB is the OUT feedback threshold voltage equal to 1.222V.
The following table lists values for R1 corresponding to the selected output voltages:
V_OUT (V)
1.25
1.5
1.8
2
2.5
2.8
3
3.3
4
5
R1 (Ω)
232
2.26k
4.75k
6.34k
10.5k
13k
14.7k
16.9k
22.6k
30.9k
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EV8802DJ-00A Rev. 1.0
www.MonolithicPower.com
4
1/25/2006
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.