EV2365DN-01A Datasheet, PDF (4/4 Pages) Monolithic Power Systems – 3A, 28V, 1.4MHz Step-Down Converter Evaluation Board

TM
EV2365DN-01A – 3A, 28V, 1.4MHz STEP-DOWN CONVERTER EVALUATION BOARD
QUICK START GUIDE
1. Connect the positive and negative terminals of the load to the VOUT and GND pins,
respectively.
2. Preset the power supply output to between 4.75V and 28V, then turn it off.
3. Connect the positive and negative terminals of the power supply output to the VIN and GND
pins, respectively.
4. Turn the power supply on (the MP2365 will automatically startup).
5. To use the Enable function, apply a digital input to the EN pin. Drive EN higher than 2.9V to turn
on the regulator or less than 0.9V to turn it off.
6. An under voltage lockout (UVLO) function can be implemented by the addition of a resistor
divider (R3 and R4). The Enable threshold is 2.6V, so the VIN UVLO threshold is:
⎜⎛1 + ^R3 ⎟⎞ × 2.6V .
⎝ ^R4 ⎠
NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third
party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not
assume any legal responsibility for any said applications.
EV2365DN-01A Rev. 1.1
www.MonolithicPower.com
4
9/20/2006
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.