EV3205DJ-00A Datasheet, PDF (3/3 Pages) Monolithic Power Systems – 1.3MHz Fixed Frequency 5 White LED Driver

TM
EV3205DJ-00A – 1.3MHz FIXED FREQUENCY 5 WHITE LED DRIVER
EVALUATION BOARD
PRINTED CIRCUIT BOARD LAYOUT
Figure 1—Top Silk Layer
Figure 2—Top Layer
QUICK START GUIDE
1. Solder LED1 through LED5 to the board.
2. Connect the positive and negative terminals of power supply (2.5V to 6V) to VIN and GND pins,
respectively.
3. Drive EN high to turn on the MP3205; low to shut it down.
4. To use burst-mode brightness control, drive EN with a PWM signal.
NOTICE: The information in this document is subject to change without notice. Please contact MPS for current specifications.
Users should warrant and guarantee that third party Intellectual Property rights are not infringed upon when integrating MPS
products into any application. MPS will not assume any legal responsibility for any said applications.
EV3205DJ-00A Rev. 1.1
www.MonolithicPower.com
3
7/13/2005
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2005 MPS. All Rights Reserved.