EV1518DG-00A Datasheet, PDF (3/3 Pages) Monolithic Power Systems – Fixed Frequency WLED Driver Evaluation Board

TM
EV1518DG-00A – FIXED FREQUENCY WLED DRIVER EVALUATION BOARD
PRINTED CIRCUIT BOARD LAYOUT
Figure 1—Top Silk Layer
Figure 2—Top Layer
Figure 3—Bottom Layer
QUICK START GUIDE
1. Solder LED1 – LED6 to board.
2. Connect the positive and negative terminals of the power supply (2.5V to 6V) to the VIN and
GND pins, respectively.
3. This board is set up for automatic startup. Pull EN low to shut down the MP1518.
4. To use burst mode brightness control, drive EN with a PWM signal.
NOTICE: The information in this document is subject to change without notice. Users should warrant and guarantee that third
party Intellectual Property rights are not infringed upon when integrating MPS products into any application. MPS will not
assume any legal responsibility for any said applications.
EV1518DG-00A Rev. 1.1
www.MonolithicPower.com
3
7/25/2006
MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.
© 2006 MPS. All Rights Reserved.