MP1011A Datasheet, PDF (1/6 Pages) Monolithic Power Systems – Cold Cathode Fluorescent Lamp Driver

MP1011A
Cold Cathode Fluorescent Lamp Driver
General Description
The MP1011A is a Power IC offering a
complete solution for driving one or more
Cold Cathode Fluorescent Lamps (CCFL).
This Power IC converts unregulated DC voltage
to a nearly pure sine wave required to ignite and
operate the CCFL. Based on proprietary power
topology and patented control techniques, it
greatly increases the power conversion
efficiency. The MP1011A supports both analog
and burst mode dimming without any additional
external components. The MP1011A offers four
distinct performance advantages:
1. More light for less power
2. Small board implementation
3. Low EMI emission
4. Low cost off the shelf components
Features
• Integrated power switches
• 6.0 to 22v variable supply voltage with
regulated lamp current.
• Rated 12W power output at 12V input
• Open lamp regulation
• Current and Voltage feedback control
• Logic Level burst mode control
• Thermal Shutdown
• Supports Open/Short Lamp protection
• Soft Start
• Output is short circuit protected
• Low lamp operating voltage for increasing
transformer or using smaller transformer
• Allows Burst-Mode Operation
• No ballast capacitor required
Ordering Information
Part Number ∗ Package
Temperature
MP1011EMA TSSOP 20 pin -20° C to + 85°C
∗ For Tape & Reel use suffix - Z (e.g. MP1011EMA-Z)
Typical Application Circuit:
Applications
LCD backlight inverter for large portable
or desktop display.
MPS, Inc 3777 Stevens Creek Blvd.
Suite 400 Santa Clara, 95051-7364 USA
Tel [phone], Fax [phone]
www.monolithicpower.com
Revision 1.7
1
April, 2001