MPM-30CM Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Chassis Mount, 30W Single, Dual & Triple Out AC/DC Power Supplies

MPM-30CM Series
Chassis Mount, 30W
Single, Dual & Triple Out
AC/DC Power Supplies
Key Features:
Electrical Specifications
Specifications typical @ +25°C, 230 VAC input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
• 30W Output Power
• Universal 85-265 VAC Input
• EN60950 Approved
• Single, Dual & Triple Outputs
• Meets EN55022 B
• Meets IEC Safety Class II
Input
Parameter
Input Voltage Range
Input Frequency
Input Current
Inrush Current
Conditions
Min. Typ.
85
47
See Model Selection Guide
115 VAC
20.0
230 VAC
40.0
Max.
265
440
Units
VAC
Hz
A Pk
• Chassis Mount Case
EMI
Meets CISPR Pub. 22/FCC Class B
DIN Rail Mounting
Kit Available!
Safety Ground Leakage Current
Output
115 VAC
230 VAC
0.1
0.3
mA
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage
See Model Selection Guide
Output Current
See Model Selection Guide
Output Voltage Accuracy, Note 1
±1.0 ±2.0
%
Line Regulation
VIN = Min to Max
±0.2 ±1.0
%
Load Regulation, Single Output
IO = Min to Max
±0.5 ±1.0
%
Load Regulation, Dual Output
IO = Min to Max
±2.5 ±5.0
%
Load Regulation, Triple Output - Primary
IO = Min to Max
±2.5 ±5.0
%
Load Regulation, Triple Output - Aux.
IO = Min to Max
±4.0
%
Ripple & Noise (20 MHz)
3.3 & 5.0 VDC Output
All Other Outputs
1.5
1.0
1.8
1.3
%VP-P of VO
Hold-Up Time
115 VAC, 60 Hz
20
mSec
Temperature Coefficient
±0.02
%/°C
Over Voltage Protection
Zener Diode Clamp
120
% of VO
Short Circuit Protection, Note 4
Continuous (Autorecovery)
Overload Protection, Note 5
Typ. 120% to 180% of Output Power
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
Input to Output 3,000
VAC
Isolation Test Voltage
Input to Output, Flash Tested For 60S 4,700
VAC
Isolation Resistance
500 VDC 100
MΩ
EMI/RFI
Conducted
EN 55022 Level B
Electrostatic Discharge (ESD)
IEC/EN 61000-4-2 Level B
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
EMC Compliance
Switching Frequency
Environmental
Parameter
Operating Temperature Range
Storage Temperature Range
Cooling
Humidity
Physical
RF Field Susceptibility
Electrical Fast Transients/Bursts On Mains
Surge
IEC/EN61000-4-3
IEC/EN 61000-4-4 Level 3 2 kV
IEC/EN 61000-4-5 Level 3 1kV/2 kV
100
kHz
Conditions
Min. Typ. Max.
Ambient -25 +25 +71
-40
+85
Free Air Convection (See Derating Curve)
RH, Non-condensing
95
Units
°C
°C
%
Case Size, Chassis Mount
4.41 x 2.51 x 1.01 Inches (112.0 x 63.8 x 25.6 mm)
Case Size, DIN Rail Option
4.41 x 2.51 x 1.44 Inches (112.0 x 63.8 x 36.6 mm)
Case Material
Non-Conductive Plastic& Fiberglass (UL94-V0)
Weight
6.72 Oz (191g)
Reliability Specifications
Parameter
Conditions
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign 250
kHours
Safety Standards
IEN 60950, IEC 60950
Safety Approvals
IEN 60950, IEC 60950
Safety Class
IEC 61140 Class II