ML100SER Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – ML100SER SERIES

ML100SER Series
Low Cost, Regulated
1W SMT, Single Output
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Key Features:
• 1W Output Power
• Miniature SMT Case
• Tight Regulation
• -40ºC to +85ºC Operation
• Short Circuit Protection
• Low 0.24” Profile
• >3.5 MHour MTBF
• Industry Standard Pin-Out
• LOW COST!
Input
Parameter
Input Voltage Range
Input Filter
Output
Parameter
Output Voltage Accuracy
Conditions
Min. Typ. Max.
5 VDC Input 4.75 5.0 5.25
12 VDC Input 11.4 12.0 12.6
15 VDC Input 14.25 15.0 15.75
24 VDC Input 22.80 24.0 25.20
Capacitor
Units
VDC
Conditions
Min. Typ. Max.
±3.0
Units
%
Line Regulation
For Vin Change of 5%
±0.3
%
Load Regulation
For Iout = 10% to 100%
±1.0
%
Output Ripple (20 MHz)
See Note 1
10 20 mV P - P
Output Noise (20 MHz)
See Note 1
50 150 mV P - P
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 1,000
M⍀
Isolation Capacitance
100 kHz, 1V
70
pF
Switching Frequency
100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.70 x 0.70 x 0.236 Inches (17.78 x 17.78 x 6.0 mm)
Case Material
Non-Conductive Black Plastic (UL94-V0)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Weight
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
0.09 Oz (2.9g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
Units
MHours
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Parameter
Input Voltage Surge (1 Sec)
Conditions
Min. Typ. Max.
5 VDC Input -0.7
7.0
12 VDC Input -0.7
15.0
15 VDC Input -0.7
18.0
Units
VDC
24 VDC Input -0.7
28.0
Lead Temperature
1.5 mm From Case For 10 Sec
260.0
ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com