|
ML100D Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – ML100D SERIES | |||
|
ML100D Series
Ultra-Miniature, 1W
Dual Output SMT
DC/DC Converters
Key Features:
⢠1W Output Power
⢠Ultra-Miniature SMT Case
⢠1,500 VDC Isolation
⢠5V, 12, & 24V Inputs
⢠-40ºC to +85ºC Operation
⢠9 Standard Models
⢠2.0 MH MTBF Minimum
⢠Available on Tape/Reel
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Electrical Speciï¬cations
Speciï¬cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Speciï¬cations subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 5.5
Input Voltage Range
12 VDC Input 10.8 12.0 13.2
VDC
24 VDC Input 21.6 24.0 26.4
Reverse Polarity Input Current
0.3
A
Input Filter
Capacitor
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±5.0
%
Output Voltage Balance
Balanced Loads
±0.1 ±1.0
%
Line Regulation
For Vin Change of 1%
±1.2 ±1.5
%
Load Regulation, See Note 1
See Model Selection Guide
Ripple & Noise (20 MHz)
See Note 2
60 120 mV P - P
Ripple & Noise (20 MHz)
Over Line, Load & Temp.
150 mV P - P
Ripple & Noise (20 MHz)
15
mv rms
Temperature Coefï¬cient
±0.01 ±0.02 %/ºC
Output Short Circuit
Momentary (0.5 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
Mï
Isolation Capacitance
100 kHz, 1V
40 100
pF
Switching Frequency
50 100 140
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Operating Temperature Range
Case
+90
ºC
Storage Temperature Range
-50
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.64 x 0.43 x 0.27 Inches (16.24 x 11.0 x 7.0 mm)
Case Material
Molding (UL94-V0)
Weight
0.07 Oz (2.0g)
Reliability Speciï¬cations
Parameter
Conditions
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25ºC, Gnd Benign 2.0
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
9.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
18.0
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec.
260
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
|
▷ |