MHI200LRI8 Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Compact, 2W SMT Ultra-High Isolation DC/DC Con vert ers

MHI200LRI8 Series
Compact, 2W SMT
Ultra-High Isolation
DC/DC Converters
Key Features:
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
• 2W Output Power
Parameter
Conditions
Min. Typ. Max. Units
• 8.0 kV Isolation
• 15 kV/µS CMTI
Input Voltage Range
• Reinforced Insulation
Input Filter
• EN 60950 Approved (Pend.) _Output
5 VDC Input 4.5 5.0 5.5
12 VDC Input 10.8 12.0 13.2
24 VDC Input 21.6 24.0 26.4
Capacitor Filter
VDC
• Compact SMT Case
Parameter
Conditions
Min. Typ. Max. Units
• -25°C to +80°C Operation ^{Output Voltage Accuracy}
• Tape & Reel Available
Output Voltage Balance
Line Regulation
Dual Output, Balanced Loads
VIN = Min to Max
±2.0 ±4.0
%
±0.1 ±1.0
%
±1.2 ±1.5
%
Load Regulation, See Note 2
See Model Selection Guide
Ripple & Noise (20 MHz)
See Note 3
150 mV P - P
Temperature Coefficient
±0.01 ±0.02 %/°C
Output Short Circuit
Momentary (0.5S Max)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
Rated For 60 Sec 4,000
Tested For 1 Sec 8,000
VAC rms
VDC
Isolation Resistance
500 VDC 10
G
Isolation Capacitance
100 kHz, 1V
15 20
pF
Common Mode Transient Immunity
15
kV/µS
Switching Frequency
50 80 100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -25 +25 +80
°C
Case
+90
Storage Temperature Range
-50
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
See Mechanical Diagram (Page 2)
Case Material
Non-Conductive Black Plastic (UL94-V0)
Weight
0.125 Oz (3.75g)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Reliability Specifications
Parameter
MTBF
Moisture Sensitivity Level (MSL)
Safety Standards
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 2.0
IPC/JEDEC J-STD-020D Level 2
UL 60950, EN 60950 (Pending)
Units
MHours
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Absolute Maximum Ratings
Parameter
Input Voltage Surge (0.1 Sec)
Conditions
Min. Typ. Max.
5 VDC Input
9.0
12 VDC Input
18.0
Units
VDC
24 VDC Input
30.0
Lead Free Reflow Solder Process
IPC/JEDEC J-STD-020D.1
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com