MG200E Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – MG200xE SERIES

MG200xE Series
Low Cost, 2W
Compact MiniDIP
DC/DC Converters
Key Features:
• 2W Output Power
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
3.3 VDC Input 2.97 3.3 3.63
• Compact MiniDIP Case
• High Efficiency
• 1,500 VDC Isolation
• Single and Dual Outputs
Input Voltage Range
Input Filter
Output
5 VDC Input 4.50 5.0
12 VDC Input 10.80 12.0
24 VDC Input 21.60 24.0
Internal Capacitor
5.50
13.20
26.40
VDC
• >3.5 MHour MTBF
• -40°C to +85°C Operation
• LOW COST
Parameter
Output Voltage Accuracy
Line Regulation
Load Regulation, See Note 1
Conditions
Min. Typ.
±2.5
For VIN Change of 1%
See Model Selection Guide
Max.
±1.2
Units
%
%
Ripple & Noise (20 MHz), See Note 2
Output Voltage <12 VDC
60
15 VDC, 24 VDC Output
75
mV P - P
3.0 kV Isolation
Models
Available
Temperature Coefficient
Output Short Circuit
General
5 VDC & 12 VDC Input
3.3 VDC & 24 VDC Input
±0.03 %/°C
Continuous (Autorecovery)
Momentary (1.0 Sec.)
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M
Isolation Capacitance
100 kHz, 0.1V
20
pF
Switching Frequency
100 300
kHz
EMI Characteristics
Parameter
Conditions
Min. Typ. Max. Units
EMI Compliance, See Note 4
Conducted
Radiated
CISPR22/EN 55022 Level B
CISPR22/EN 55022 Level B
EMC Compliance, Single Output
EMC Compliance, Dual Output
Electrostatic Discharge (ESD) ^{EN 61000-4-2 Level B Contact ±8 kV}
EN 61000-4-2 Level B Contact ±6 kV
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.787 x 0.394 x 0.323 Inches (20.0 x 10.0 x 8.2 mm)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Case Material
Weight
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
Non-Conductive Black Plastic (UL-94V0)
0.08 Oz (2.4g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 3.5
Units
MHours
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Parameter
Input Voltage Surge (1 Sec)
Conditions
Min. Typ. Max.
3.3 VDC Input -0.7
5.0
5 VDC Input -0.7
9.0
12 VDC Input -0.7
18.0
Units
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com