MF3000ERU Datasheet, PDF (1/4 Pages) MicroPower Direct, LLC – MF3000ERU

MF3000ERU
Wide 4:1 Input, 30W
Single & Dual Output
DC/DC Converters
Electrical Specifications
Key Features:
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
• 30W Output Power
• 4:1 Input Voltage Range
• 1,500 VDC Isolation
• Single & Dual Outputs
• Efficiency to 90%
Parameter
Input Voltage Range
Under Voltage Lockout
Conditions
Min. Typ. Max.
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 75.0
24 VDC Input
On
9.0
Off 7.8
48 VDC Input
On
17.8
Off 16.0
Units
VDC
VDC
• Compact 1.6 x 2 Inch Case ^{Input Filter}
• -40°C to +85°C Operation
Output
Parameter
• Industry Standard Pin-Out Output Voltage Accuracy
Conditions
␲ (Pi) Filter
Min. Typ. Max.
±1.0 ±3.0
Units
%
• Low Cost
Output Trim Range
Line Regulation
VIN = Min to Max
±10
%
±0.2 ±0.5
%
Load Regulation
IOUT = 5% to 100%
±0.5 ±1.0
%
Cross Regulation
See Note 1
±5.0
%
Ripple & Noise (20 MHz)
See Note 2
85 100 mV P - P
Transient Recovery Time, See Note 3
Transient Response Deviation
25% Load Step Change
300 500
±3.0 ±5.0
µSec
%
Temperature Coefficient
±0.02
%/°C
Over Power Protection
150
%IOUT
Output Short Circuit, See Note 4
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M
Isolation Capacitance
100 kHz, 0.1V
2,000
pF
Switching Frequency
400
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Operating Temperature Range
Case
+105
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
2.0 x 1.60 x 0.465 Inches (50.8 x 40.6 x 11.8 mm)
Case Material
Aluminum Alloy With Non-Conductive Base (UL94-V0)
Weight
Without Heatsink
1.77 Oz (50g)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Remote On/Off
Parameter
Unit On
Unit Off
Off Idle Current
With Heatsink
2.48 Oz (70g)
Conditions
Min. Typ. Max.
See Note 5 2.5
12.0
See Note 5 0
1.2
1.0
Units
VDC
VDC
mA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 1.0
Conditions
Min. Typ. Max.
Units
MHours
Units
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
48 VDC Input -0.7
50.0
100.0
VDC
Lead Temperature
1.5 mm From Case for 10 Sec
300
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com