MA100RU Datasheet, PDF (1/4 Pages) MicroPower Direct, LLC – MA100RU SERIES

MA100RU _Series
Wide 4:1 Input, 1.5W,
Single & Dual Output
DC/DC Converters
Key Features:
• 1.5W Output Power
• 4:1 Input Voltage Range
• 1,500 VDC Isolation
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 72.0
VDC
• 20 Standard Models
Input Reflected Ripple Current
35
mA P - P
• High Efficiency
Input Filter
␲ (Pi) Filter
• Compact DIP Case
• -40°C to +85°C Operation
• Metal Case Available
• Low Cost
Output
Parameter
Output Voltage Accuracy
Line Regulation
Load Regulation
Conditions
Min.
VIN = Min to Max
IOUT = 25% to 100%
Typ.
±1.0
±0.5
±0.5
Max.
Units
%
%
%
Cross Regulation
See Note 1
±0.5
%
Ripple & Noise (20 MHz)
See Note 2
60
mV P - P
Alternate
Pin-Out
Available
Temperature Coefficient
Output Short Circuit
General
Parameter
±0.02
Continuous (Autorecovery)
%/°C
Conditions
Min. Typ. Max. Units
Isolation Voltage, See Note 3
3 Seconds 1,500
VDC
1.5 kV Isolation
Models
Available
Isolation Resistance
Isolation Capacitance
Switching Frequency
Environmental
500 VDC 1,000
M
100 kHz/0.1V
60
pF
100
400
kHz
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Operating Temperature Range
Case
+100
°C
Storage Temperature Range
-40
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
1.25 x 0.80 x 0.40 Inches (31.75 x 20.32 x 10.16 mm)
Case Material, Plastic
Non-Conductive Black Plastic (UL94-V0)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Weight, Plastic Case
Case Material, Metal
Weight, Metal Case
Reliability Specifications
Parameter
0.44 Oz (12.5g)
Nickel-Coated Copper With Non-Conductive Base (UL94-V0)
0.53 Oz (15g)
Conditions
Min. Typ. Max. Units
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
MTBF
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
MIL HDBK 217F, 25°C, Gnd Benign 1.0
MHours
Conditions
Min. Typ. Max.
24 VDC Input -0.7
40.0
48 VDC Input -0.7
80.0
Units
VDC
Lead Temperature
1.5 mm From Case for 10 Sec
260
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com