LF200D Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Ultra-Miniature, 2W Dual Output SMT DC/DC Converters

LF200D _Series
Ultra-Miniature, 2W
Dual Output SMT
DC/DC Converters
Key Features:
• 2W Output Power
• Ultra-Miniature SMT Case
• 1,000 VDC Isolation
• 5V, 12 & 24V Inputs
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 5.5
Input Voltage Range
12 VDC Input 10.8 12.0 13.2
VDC
24 VDC Input 21.6 24.0 26.4
Reverse Polarity Input Current
0.3
A
• -40ºC to +85ºC Operation
• 7 Standard Models
• 2.0 MH MTBF Minimum
• Industry Standard Pin-Out
Input Filter
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
Capacitor
Conditions
Min.
Dual Output, Balanced Load
Typ.
±1.5
±0.1
Max.
±4.0
±1.0
Units
%
%
Line Regulation
For Vin Change of 1%
±1.2 ±1.5
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
50 75 mV P - P
Ripple & Noise (20 MHz)
Over Line, Load & Temp.
150 mV P - P
Ripple & Noise (20 MHz)
5
mv rms
Output Power Protection
120
%
RoHS Compliant
Temperature Coefficient
Output Short Circuit
±0.01 ±0.02
Momentary (0.5 Sec.)
%/ºC
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 10
GΩ
Isolation Capacitance
100 kHz, 1V
60 100
pF
Switching Frequency
70 100 120
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Operating Temperature Range
Case -40
+90
ºC
Storage Temperature Range
-40
+125
ºC
Cooling
Free Air Convection
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Humidity
Physical
Case Size
Case Material
Weight
RH, Non-condensing
95
%
0.60 x 0.36 x 0.34 Inches (15.3 x 9.3 x 8.7 mm)
Molding (UL94-V0)
0.07 Oz (2.2g)
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 2.0
Units
MHours
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
5 VDC Input -0.7
12 VDC Input -0.7
9.0
VDC
18.0
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec.
300
ºC
Internal Power Dissipation
All Models
650
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.