|
G100E_14 Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – G100E Series | |||
|
G100E Series
Low Cost, 1W MiniDIP
Single & Dual Output
DC/DC Converters
Key Features:
⢠1W Output Power
⢠Compact âMiniDIPâ Case
⢠EN 60950 Approved (UL)
Electrical Speciï¬cations
Speciï¬cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Speciï¬cations subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 5.5
Input Voltage Range
12 VDC Input 10.8 12.0 13.2
VDC
24 VDC Input 21.6 24.0 26.4
⢠Single & Dual Outputs
Input Filter
Internal Capacitor
⢠1,000 VDC Isolation
⢠>3.5 MHour MTBF
⢠24 Standard Models
⢠LOWEST COST!!
Reverse Polarity Input Current
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
0.3
Conditions
Min. Typ. Max.
±1.0 ±3.0
Dual Output , Balanced Loads
±0.1 ±1.0
A
Units
%
%
Line Regulation
For Vin Change of 1%
±1.2
%
Load Regulation, See Note 1
See Model Selection Guide
Ripple & Noise (20 MHz)
Single Output, See Note 3
Dual Output, See Note 3
75 100
mV P - P
50 750
Output Power Protection
120
%
Temperature Coefï¬cient
±0.02 ±0.03 %/ºC
Output Short Circuit
Momentary (1.0 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 1,000
Mï
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.79 x 0.39 x 0.28 Inches (20.0 x 10.0 x 7.0 mm)
Case Material
Non-Conductive Black Plastic (UL94-V0)
Weight
0.07 Oz (2.1g)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Reliability Speciï¬cations
Parameter
MTBF
Safety Standards
Safety Approvals
Conditions
Min. Typ.
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
UL 1950, EN 60950
UL, cUL; File No. E245422
Max.
Units
MHours
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
Conditions
Min. Typ. Max.
5 VDC Input -0.7
9.0
12 VDC Input -0.7
18.0
Units
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
|
▷ |