G100E Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost, 1W MiniDIP Single & Dual Output DC/DC Converters

G100E Series
Low Cost, 1W MiniDIP
Single & Dual Output
DC/DC Converters
Key Features:
• 1W Output Power
• Compact “MiniDIP” Case
• UL Approved (File E245422)
• Single & Dual Outputs
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 5.5
Input Voltage Range
12 VDC Input 10.8 12.0 13.2
VDC
24 VDC Input 21.6 24.0 26.4
Input Filter
Internal Capacitor
• 1,000 VDC Isolation
Reverse Polarity Input Current
0.3
A
• >3.5 MHour MTBF
• 24 Standard Models
• LOWEST COST!!
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
Conditions
Min.
Dual Output , Balanced Loads
Typ.
±1.0
±0.1
Max.
±3.0
±1.0
Units
%
%
Line Regulation
For Vin Change of 1%
±1.2
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
50 75 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.02 ±0.03 %/ºC
Output Short Circuit
RoHS Compliant _General
Momentary (1.0 Sec.)
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Case Size
Case Material
Weight
Reliability Specifications
Parameter
0.80 x 0.40 x 0.25 Inches (20.4 x 10.2 x 6.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.07 Oz (2.1g)
Conditions
Min. Typ. Max. Units
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
MTBF
Safety Standards
Safety Approvals
Absolute Maximum Ratings
MIL HDBK 217F, 25ºC, Gnd Benign 3.5
UL 1950, EN 60950, IEC 60950
UL, cUL; File No. E245422
MHours
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
9.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
18.0
VDC
24 VDC Input -0.7
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
450
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.