F3000TERU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – F3000TERU SERIES

F3000TERU _Series
Compact, 4:1 Input
30W, Triple Output
DC/DC Converters
Key Features:
• 30W Output Power
• 4:1 Input Voltage Range
• 1,500 VDC Isolation
• Triple Outputs
• Compact 1.6 x 2 In. Case
• -40ºC to +85ºC Operation
• >1.0 MHour MTBF
• Remote ON/OFF
• Industry Standard Pin-Out
Single & Dual
Output Models
Available
F3000ERU Series
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 75.0
VDC
Under Voltage Shutdown
Input Filter, See Note 1
Input Reflected Ripple Current
Start Up Time
Output
Parameter
24 VDC Input 8.0
9.0
48 VDC Input 16.0
17.8
␲ (Pi) Filter
30
10
Conditions
Min. Typ. Max.
VDC
mA
mS
Units
Output Voltage Accuracy
Line Regulation, For VIN Min to Max
Load Regulation, IOUT = 10% to 100%
Main Output
Auxiliary Outputs
Main Output
Auxiliary Outputs
Main Output
Auxiliary Outputs
±1.0 ±3.0
±3.0 ±5.0
%
±1.0
%
±5.0
±2.0
%
±5.0
Ripple & Noise, See Note 2
Output Power Protection
85 120 mV P - P
110 130
%
Transient Recovery Time, See Note 3
Transient Response Deviation
25% Load Step Change
300 500
±3.0 ±5.0
µSec
%
Temperature Coefficient
±0.03
%/°C
Output Short Circuit
General
Parameter
Continuous (Autorecovery)
Conditions
Min. Typ. Max.
Units
Isolation Voltage
Isolation Resistance
Isolation Capacitance
Switching Frequency
Remote On/Off (Note 4)
Parameter
60 Seconds
500 VDC
100 kHz, 0.1V
1,500
1,000
2,000
400
Conditions
Min. Typ. Max.
VDC
M⍀
pF
kHz
Units
Supply On
3.5
12.0
VDC
Supply Off
Standby Input Current
-0.0
1.2
VDC
1
mA
Control Common
Environmental
Parameter
Conditions
Referenced to Negative Input (pin 2)
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40
Case
+85
°C
+105
°C
Storage Temperature Range
Cooling
-55
Free Air Convection
+125
°C
Humidity
RH, Non-condensing
95
%
Physical
Case Size
2.0 x 1.6 x 0.42 Inches (50.8 x 40.6 x 11.8 mm)
Case Material
Weight
Reliability Specifications
Parameter
Conditions
Metal with Non-Conductive Base
1.76 Oz (50g)
Min. Typ. Max. Units
MTBF
Absolute Maximum Ratings
Parameter
MIL HDBK 217F, 25°C, Gnd Benign 1,000
Conditions
Min. Typ. Max.
kHours
Units
Input Voltage Surge (1 Sec)
Lead Temperature
24 VDC Input -0.7
48 VDC Input -0.7
1.5 mm From Case For 10 Sec
40.0
80.0
VDC
300
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com