F2000ERW_14 Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – F2000ERW SERIES

F2000ERW _Series
Low Cost, Compact
20W, 2:1 Input Range
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Key Features:
• 20W Output Power
• 2:1 Input Voltage Range
• 1,500 VDC Isolation
• Single & Dual Outputs
• Efficiency to 86%
• Compact 1.6 x 2 In. Case
• -40°C to +71°C Operation
• Industry Standard Pin-Out
• Lowest Cost!!
Input
Parameter
Input Start Voltage
Input Filter
Short Circuit Input Power
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
Conditions
Min.
12 VDC Input 8.6
24 VDC Input 17.5
48 VDC Input 34.0
LC Filter
Typ.
8.8
17.8
35.0
3,500
Max.
9.0
18.0
36.0
Conditions
Min. Typ. Max.
±1.0 ±3.0
Dual Output, Balanced Loads
±0.5
Units
VDC
mW
Units
%
%
Line Regulation
Vin = Min to Max
±0.2 ±0.5
%
Load Regulation
Iout = 10% to 100%
±0.5 ±1.0
%
Ripple & Noise (20 MHz)
See Note 1
75 150 mV P - P
Output Power Protection
See Note 3 120 130 150
%
Transient Recovery Time (Note 4)
Transient Response Deviation
25% Load Step Change
200 300
±2.0 ±5.0
µSec
%
Temperature Coefficient
±0.02
%/°C
Output Short Circuit
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 500
M⍀
Isolation Capacitance
100 kHz, 1V
1,000
pF
Switching Frequency
300
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient
-40 +25 +71
°C
Storage Temperature Range
-50
+105
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
2.0 x 1.6 x 0.41 Inches (50.8 x 40.6 x 10.5 mm)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Case Material
Weight
Reliability Specifications
Parameter
MTBF
Metal With Non-Conductive Base (UL94-V0)
1.37 Oz (39g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 100
Units
kHours
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
Conditions
12 VDC Input
24 VDC Input
Min. Typ. Max.
-0.7
20.0
-0.7
40.0
Units
VDC
48 VDC Input
-0.7
80.0
Lead Temperature
1.5 mm From Case for 10 Sec
300
°C
Internal Power Dissipation
All Models
5,000
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com