E200E Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost, 2W Ultra-Miniature SIP DC/DC Converters

E200E _Series
Low Cost, 2W
Ultra-Miniature SIP
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Key Features:
Input
Parameter
Conditions
Min. Typ. Max. Units
• 2W Output Power
• Ultra-Miniature SIP Case
• Low 0.3” Profile
• 1,000 VDC Isolation
• >3.5 MHour MTBF
• 5V & 12V Inputs
• LOWEST COST!
Input Voltage Range
Reverse Polarity Input Current
Input Filter
Output
Parameter
Output Voltage Accuracy
Line Regulation
5 VDC Input 4.5 5.0 5.5
12 VDC Input 10.8 12.0 13.2
0.3
Internal Capacitor
VDC
A
Conditions
Min.
For Vin Change of 1%
Typ.
±1.0
Max.
±3.0
±1.2
Units
%
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
50 75 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.01 ±0.03 %/°C
Output Short Circuit
Momentary (0.5 Sec.)
General
RoHS Compliant _Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Test Voltage
Flash Tested For 1 Sec 1,100
VDC
Isolation Resistance
1,000 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
60 100
pF
Switching Frequency
75
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Operating Temperature Range
Case
+90
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Humidity
Physical
Case Size
Case Material
Weight
Reliability Specifications
Parameter
MTBF
RH, Non-condensing
95
%
0.46 x 0.40 x 0.30 Inches (11.6 x 10.2 x 7.55 mm)
Non-Conductive Black Plastic (UL-94V0)
0.06 Oz (1.8g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 3.5
Units
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
5 VDC Input -0.7
12 VDC Input -0.7
9.0
VDC
18.0
Lead Temperature
1.5 mm From Case For 10 Sec
260
°C
Internal Power Dissipation
All Models
650
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.