|
E100EI Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – 1W, High Isolation Ultra-Miniature SIP DC/DC Converters | |||
|
E100EI Series
1W, High Isolation
Ultra-Miniature SIP
DC/DC Converters
Key Features:
⢠1W Output Power
⢠Ultra-Miniature SIP Case
⢠3,000 VDC Isolation
Electrical Speciï¬cations
Speciï¬cations typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Speciï¬cations subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
3.3 VDC Input 2.97 3.3 3.63
Input Voltage Range
5 VDC Input 4.50 5.0 5.50
12 VDC Input 10.80 12.0 13.20
VDC
⢠14 Standard Models
24 VDC Input 21.60 24.0 26.40
⢠>3.5 MHour MTBF
⢠3.3V, 5V, 12V & 24V Inputs
⢠LOWEST COST!!
Reverse Polarity Input Current
Input Filter
Output
Parameter
0.3
Internal Capacitor
Conditions
Min. Typ. Max.
A
Units
Output Voltage Accuracy
±1.0 ±3.0
%
Line Regulation, 3.3V Input Models
All Other Models
For Vin Change of 1%
±1.5
%
±1.2
Load Regulation, See Note 1
See Model Selection Guide
Ripple & Noise (20 MHz)
See Note 3
100 150 mV P - P
Temperature Coefï¬cient
±0.01 ±0.03 %/°C
Output Short Circuit, See Note 4
Momentary (1.0 Sec.)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 3,000
VDC
Isolation Resistance
500 VDC 1,000
Mï
Isolation Capacitance
100 kHz, 1V
60
pF
Switching Frequency
100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
0.45 x 0.23 x 0.295 Inches (11.5 x 6.0 x 7.5 mm)
Case Material
Non-Conductive Black Plastic (UL-94V0)
Weight
0.04 Oz (1.1g)
Reliability Speciï¬cations
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Parameter
MTBF
Shock & Vibration, See Note 5
Absolute Maximum Ratings
Parameter
Conditions
MIL HDBK 217F, 25°C, Gnd Benign
Min. Typ. Max. Units
3.5
MHours
Meets MIL-STD-202F, IEC68-2-6
Conditions
Min. Typ. Max. Units
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Input Voltage Surge (1 Sec)
3.3 VDC Input -0.7
5 VDC Input -0.7
12 VDC Input -0.7
24 VDC Input -0.7
7.0
9.0
VDC
18.0
30.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Internal Power Dissipation
All Models
650
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com
|
▷ |