D300RW Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Single & Dual Output 3W SIP, Wide Input DC/DC Converters

D300RW _Series
Single & Dual Output
3W SIP, Wide Input
DC/DC Converters
Key Features:
• 3W Output Power
• 2:1 Input Voltage Range
• 1,500 VDC Isolation
• Short Circuit Protected
• Miniature SIP Case
• Single & Dual Outputs
• 1.0 MH MTBF
• Industry Standard Pin-Out
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
12 VDC Input 9.0 12.0 18.0
24 VDC Input 18.0 24.0 36.0
VDC
Short Circuit Input Power
1,500
mW
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.0 ±3.0
%
Output Voltage Balance
±1.0 ±2.0
%
Line Regulation
Vin = Min to Max
±0.2 ±0.5
%
Load Regulation , Single Output
Iout = 10% to 100%
±0.5 ±0.75
%
Load Regulation , Dual Output
Iout = 10% to 100%
±0.5 ±1.0
%
Ripple & Noise (20 MHz) (Note 1)
50 100 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/°C
Output Short Circuit
Continuous (Autorecovery)
General
RoHS Compliant Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
80
pF
Switching Frequency
Iout = 100% 200
500
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Storage Temperature Range
-50
+125
°C
Cooling
Free Air Convection
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Humidity
Physical
Case Size
Case Material
Weight
Reliability Specifications
Parameter
MTBF
RH, Non-condensing
95
%
0.87 x 0.47 x 0.37 Inches (22.0 x 12.0 x 9.50 mm)
Non-Conductive Black Plastic (UL94-V0)
0.20 Oz (6.0g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 1.0
Units
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
24 VDC Input -0.7
22.0
VDC
40.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Internal Power Dissipation
All Models
1,800
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.