D200RU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Miniature SIP, 2W Ultra-Wide 4:1 Input DC/DC Converters

D200RU Series
Miniature SIP, 2W
Ultra-Wide 4:1 Input
DC/DC Converters
Key Features:
• 2W Output Power
• 4:1 Input Voltage Range
• 1,000 VDC Isolation
• Short Circuit Protected
• Miniature SIP Case
• Single & Dual Outputs
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Start Voltage
24 VDC Input 4.5
48 VDC Input 8.5
6.0 8.5
12.0 17.0
VDC
Input Filter
Capacitor Filter
Reverse Polarity Input Current
0.5
A
Short Circuit Input Power
1,500
mW
Output
• 1.0 MH MTBF
Parameter
Conditions
Min. Typ. Max. Units
• Industry Standard Pin-Out ^{Output Voltage Accuracy}
Output Voltage Balance
±1.0 ±2.0
%
±1.0 ±2.0
%
Line Regulation
Vin = Min to Max
±0.3 ±0.5
%
Load Regulation
Iout = 25% to 100%
±0.5 ±0.75
%
Ripple & Noise (20 MHz) (Note 1)
30 50 mV P - P
Ripple & Noise (20 MHz)
Over Line, Load & Temp.
75 mV P - P
Ripple & Noise (20 MHz)
15 mV rms
Output Power Protection
120
%
Transient Response Time (Note 2)
Transient Response Deviation
25% Load Step Change
100 300
±3.0 ±5.0
μSec
%
RoHS Compliant
Temperature Coefficient
Output Short Circuit
±0.01 ±0.02
Continuous
%/°C
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,000
VDC
Isolation Test Voltage
Flash Tested For 1 Sec 1,100
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
250 500
pF
Switching Frequency
300
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +65
°C
Operating Temperature Range
Case -40 +25 +65
°C
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Storage Temperature Range
Cooling
Humidity
Physical
Case Size
-55
Free Air Convection
RH, Non-condensing
+105
°C
95
%
1.02 x 0.36 x 0.49 Inches (25.95 x 9.25 x 12.45 mm)
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Case Material
Weight
Reliability Specifications
Parameter
Conditions
Non-Conductive Black Plastic (UL94-V0)
0.23 Oz (6.5g)
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign 1,000
kHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
48 VDC Input -0.7
50.0
100.0
VDC
Lead Temperature
1.5 mm From Case For 10 Sec
260
°C
Internal Power Dissipation
All Models
2,500
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.