D200ERW Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost, Miniature 2W SIP, Wide Input DC/DC Con vert ers

D200ERW _Series
Low Cost, Miniature
2W SIP, Wide Input
DC/DC Converters
Key Features:
• 2W Output Power
• 2:1 Input Voltage Range
• 1,500 VDC Isolation
• Short Circuit Protected
• Miniature SIP Case
• Single & Dual Outputs
• 1.0 MH MTBF
• Industry Standard Pin-Out
• Low Low Cost!!
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
5 VDC Input 4.5 5.0 9.0
Input Voltage Range
12 VDC Input 9.0 12.0 18.0
24 VDC Input 18.0 24.0 36.0
VDC
48 VDC Input 36.0 48.0 72.0
Reverse Polarity Input Current
1.0
A
Short Circuit Input Power
1,500
mW
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.0 ±3.0
%
Output Voltage Balance
±1.0 ±2.0
%
Line Regulation
Vin = Min to Max
±0.2 ±0.5
%
Load Regulation , Single Output
Iout = 10% to 100%
±0.5 ±0.75
%
Load Regulation , Dual Output
Iout = 10% to 100%
±0.5 ±1.0
%
Ripple & Noise (20 MHz)
See Note 1
35 100 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/°C
Output Short Circuit
Continuous (Autorecovery)
RoHS Compliant ^General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
80
pF
Switching Frequency
Iout = 100% 180
500
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Storage Temperature Range
-50
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Physical
Case Size
Case Material
Weight
Reliability Specifications
0.87 x 0.47 x 0.37 Inches (22.0 x 12.0 x 9.50 mm)
Non-Conductive Black Plastic (UL94-V0)
0.19 Oz (5.5g)
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Parameter
MTBF
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
MIL HDBK 217F, 25°C, Gnd Benign 1.0
MHours
Conditions
Min. Typ. Max. Units
5 VDC Input -0.7
11.0
Input Voltage Surge (1 Sec)
12 VDC Input -0.7
24 VDC Input -0.7
22.0
VDC
40.0
48 VDC Input -0.7
80.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Internal Power Dissipation
All Models
1,800
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.