D200ERU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost, 4:1 Input Miniature, 2W SIP DC/DC Converters

D200ERU _Series
Low Cost, 4:1 Input
Miniature, 2W SIP
DC/DC Converters
Key Features:
• 2W Output Power
• 4:1 Input Voltage Range
• 1,500 VDC Isolation
• Short Circuit Protected
• Miniature SIP Case
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 72.0
VDC
Reverse Polarity Input Current
1.0
A
Short Circuit Input Power
1,500
mW
• Single & Dual Outputs
Output
• 1.0 MH MTBF
• Industry Standard Pin-Out
• Low Low Cost!!
Parameter
Output Voltage Accuracy
Output Voltage Balance
Conditions
Min.
Typ.
±1.0
±1.0
Max.
±3.0
±2.0
Units
%
%
Line Regulation
Vin = Min to Max
±0.2 ±0.75
%
Load Regulation
Iout = 10% to 100%
±0.5 ±1.5
%
Ripple (20 MHz)
See Note 1
15 30 mV P - P
Noise (20 MHz)
50 150 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/°C
Output Short Circuit
Continuous (Autorecovery)
General
RoHS Compliant Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
65
pF
Switching Frequency , Single Output
Iout = 100% 100
650
kHz
Switching Frequency , Dual Output
Iout = 100% 200
400
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +85
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Humidity
Physical
Case Size
Case Material
Weight
Reliability Specifications
Parameter
MTBF
RH, Non-condensing
95
%
1.02 x 0.37 x 0.49 Inches (26.0 x 9.50 x 12.50 mm)
Non-Conductive Black Plastic (UL94-V0)
0.24 Oz (7.0g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25°C, Gnd Benign 1.0
Units
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
48 VDC Input -0.7
40.0
VDC
80.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Internal Power Dissipation
All Models
1,800
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.