English
Language : 

D100VHI Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Miniature, 1W SIP Ultra-High Isolation DC/DC Converters
D100VHI Series
Miniature, 1W SIP
Ultra-High Isolation
DC/DC Converters
Key Features:
• 1W Output Power
• 6.0 kVDC Isolation
• Miniature SIP Case
• Single & Dual Outputs
• Miniature SIP Case
• 12 Standard Models
• 2.0 MH MTBF
• Industry Standard Pin-Out
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
5 VDC Input 4.5 5.0 5.5
12 VDC Input 10.8 12.0 13.2
VDC
Input Filter
Internal Capacitor
Reverse Polarity Input Current
0.3
A
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.0 ±3.0
%
Output Voltage Balance
Dual Output , Balanced Loads
±0.1 ±1.0
%
Line Regulation
For Vin Change of 1%
±1.2 ±1.5
%
Load Regulation (Note 1)
See Model Selection Guide
Ripple & Noise (20 MHz) (Note 2)
100 150 mV P - P
Ripple & Noise (20 MHz)
Over Line, Load & Temp.
200 mV P - P
Ripple & Noise (20 MHz)
5
mV rms
Output Power Protection
120
%
Temperature Coefficient
±0.01 ±0.02 %/°C
Output Short Circuit
Momentary (0.5 Sec.)
RoHS Compliant General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 6,000
VDC
Isolation Test Voltage
Flash Tested For 1 Sec 6,600
VDC
Isolation Resistance
500 VDC 10
GΩ
Isolation Capacitance
100 kHz, 1V
15 20
pF
Switching Frequency
50 80 100
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +70
°C
Operating Temperature Range
Case -40
+90
°C
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Storage Temperature Range
Cooling
Humidity
Physical
Case Size
Case Material
Weight
Reliability Specifications
Parameter
-40
Free Air Convection
RH, Non-condensing
+125
°C
95
%
0.87 x 0.49 x 0.30 Inches (22.0 x 12.5 x 7.5 mm)
Non-Conductive Black Plastic (UL94-V0)
0.13 Oz (3.9g)
Conditions
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign 2.0
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
5 VDC Input -0.7
12 VDC Input -0.7
9.0
VDC
18.0
Lead Temperature
1.5 mm From Case For 10 Sec
260
°C
Internal Power Dissipation
All Models
650
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.