C4000ERW_14 Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – C4000ERW SERIES

C4000ERW _Series
Compact, 2:1 Input
40W, Single Output
DC/DC Converters
Key Features:
• 40W Output Power
• 2:1 Input Voltage Range
• 1,500 VDC Isolation
• Compact 2 x 2 In. Case
• -40ºC to +60ºC Operation
• >1.0 MHour MTBF
• Remote ON/OFF
• Industry Standard Pin-Out
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
12 VDC Input 9.0 12.0 18.0
Input Voltage Range
24 VDC Input 18.0 24.0 36.0
VDC
48 VDC Input 36.0 48.0 75.0
12 VDC Input 8.0
9.0
Under Voltage Shutdown
24 VDC Input 16.0
17.8
VDC
48 VDC Input 33.0
36.0
Input Filter
␲ (Pi) Filter
Start Up Time
See Note 1
2.0
A
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.0
%
Line Regulation
For Vin Min to Max
±0.2
%
Load Regulation
Iout = 10% to 100%
±0.5
%
Ripple & Noise (20 MHz) (Note 1)
75 150 mV P - P
Output Power Protection
120
150
%
Over Voltage Protection
110
130 % Vout
Transient Recovery Time (Note 2)
Transient Response Deviation
25% Load Step Change
200 500
±5.0
µSec
%
Temperature Coefficient
±0.02
%/°C
Output Short Circuit
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M⍀
Isolation Capacitance
100 kHz, 0.1V
2,000
pF
Switching Frequency
300
kHz
Over Temperature Protection
Case Temperature
115
°C
Remote On/Off (Note 3)
Parameter
Conditions
Min. Typ. Max. Units
Supply On
3.5
12.0
VDC
Supply Off
-0.0
1.2
VDC
Standby Input Current
1
mA
Control Common
Referenced to Negative Input (pin 2)
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40
+60
°C
Storage Temperature Range
-55
+125
°C
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
2.0 x 2.0 x 0.42 Inches (50.8 x 50.8 x 10.6 mm)
Case Material
Metal with Non-Conductive Base
Weight
2.19 Oz (60g)
Reliability Specifications
Parameter
Conditions
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign 1,000
kHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
12 VDC Input -0.7
20.0
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
40.0
VDC
48 VDC Input -0.7
80.0
Lead Temperature
1.5 mm From Case For 10 Sec
300
°C
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com