B1000ERW Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Low Cost 1 x 2 Inch 10W Wide Input Range DC/DC Converters

B1000ERW Series
Low Cost 1 x 2 Inch 10W
Wide Input Range
DC/DC Converters
A
Budget
Key Features:
• 10W Output Power
• 2:1 Input Voltage Range
• 1,500 VDC Isolation
Electrical Specifications
Saver!!
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
12 VDC Input 9.0 12.0 18.0
Input Voltage Range
24 VDC Input 18.0 24.0 36.0
VDC
• Efficiency to 86%
48 VDC Input 36.0 48.0 72.0
• Compact 1 x 2 Inch Case
• Single & Dual Outputs
• Industry Standard Pin-Out
Input Filter
Short Circuit Input Power
Output
Parameter
Conditions
π (Pi) Filter
1,500
Min. Typ. Max.
mW
Units
• Lowest Cost!!
Output Voltage Accuracy
±3.0
%
Output Voltage Balance
Dual Output , Balanced Loads
±5.0
%
Line Regulation
Vin = Min to Max
±0.1 ±0.2
%
Positive Load Regulation
Iout = 25% to 100%
0.2 0.5
%
Negative Load Regulation
Iout = 25% to 100%
3.0 5.0
%
Ripple
Bandwidth = 20 Hz to 300 kHz
30 50 mV P - P
Noise
Bandwidth = DC to 20 MHz
100 mV P - P
RoHS Compliant
Output Power Protection
Transient Recovery Time (Note 1)
Transient Response Deviation
110
200
25% Load Step Change
±2.0
%
µSec
%
Temperature Coefficient
±0.01 ±0.02 %/°C
Output Short Circuit
Continuous
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
MΩ
Isolation Capacitance
100 kHz, 1V
130
pF
Switching Frequency
300
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40 +25 +71
°C
Operating Temperature Range
Case -40 +25 +90
°C
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Storage Temperature Range
Cooling
Humidity
Physical
Case Size
-40
Free Air Convection
RH, Non-condensing
+125
°C
95
%
2.0 x 1.0 x 0.40 Inches (50.8 x 25.4 x 10.2 mm)
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Case Material
Weight
Reliability Specifications
Parameter
Conditions
Non-Conductive Black Plastic (UL94-V0)
1.06 Oz (30g)
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25°C, Gnd Benign 1.0
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
12 VDC Input -0.7
25.0
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
45.0
VDC
48 VDC Input -0.7
100.0
Lead Temperature
1.5 mm From Case for 10 Sec
300
°C
Internal Power Dissipation
All Models
5,000
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.