English
Language : 

A600ERU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Single & Dual Output, 6W Ultra-Wide Input Range DC/DC Converters
A600ERU Series
Single & Dual Output, 6W
Ultra-Wide Input Range
DC/DC Converters
Key Features:
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
• 6W Output Power
• 4:1 Input Voltage Range
Input Voltage Range (See Note 1)
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 72.0
VDC
• 1,500 VDC Isolation
• -40ºC to +85ºC Temp Range
• Compact DIP Case
• Single & Dual Outputs
• 1.0 MH MTBF
• Industry Standard Pin-Out
• Low, Low Cost
Input Filter
Reverse Polarity Input Current
Short Circuit Input Power
Output
Parameter
Output Voltage Accuracy
Output Voltage Balance
Line Regulation
Capacitors
1.0
A
2,500
mW
Conditions
Min. Typ. Max.
See Note 2
±1.0 ±3.0
Dual Output , Balanced Loads
±3.0
Vin = Min to Max
±0.2 ±0.5
Units
%
%
%
Load Regulation
See Note 3
±0.5 ±1.0
%
Noise (20 Hz - 300 kHz)
See Note 4
30 50 mV P - P
Ripple (DC - 20 MHz)
100 300 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.01 ±0.02 %/ºC
Output Short Circuit
Continuous
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M⍀
Switching Frequency
Single Output
300
kHz
Dual Output
250
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40
+85
ºC
Storage Temperature Range
-55
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size
1.25 x 0.80 x 0.40 Inches (31.8 x 20.3 x 10.2 mm)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: (781) 344-8226
F: (781) 344-8481
E: sales@micropowerdirect.com
W: www.micropowerdirect.com
Case Material
Weight
Reliability Specifications
Parameter
MTBF
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
Metal With Non-Conductive Base (UL94V-0)
0.49 Oz (14g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 1.0
Units
MHours
Conditions
24 VDC Input
48 VDC Input
Min.
-0.7
-0.7
Typ. Max.
50.0
100.0
Units
VDC
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
2,500
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com