A1200RU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – A1200RU SERIES

A1200RU _Series
4:1 Input Range, 12W
Single & Dual Output
DC/DC Converters
Key Features:
• 12W Output Power
• 4:1 Input Voltage Range
• Compact DIP Case
• EN 60950 Compliant
• Meets EN 55022 “A”
• Single & Dual Outputs
• 1.0 MH MTBF
• Industry Standard Pin-Out
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Input
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Range
Input Filter
Input Reflected Ripple Current
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 75.0
␲ (Pi) Filter (Meets EN 55022 Class “A”)
20.0
VDC
mA P - P
Output
Parameter
Conditions
Min. Typ. Max. Units
Output Voltage Accuracy
±1.2
%
Output Voltage Balance
Dual Output , Balanced Loads
±0.5
%
Line Regulation
Load Regulation, Single Output
Load Regulation, Dual Output
Vin = Min to Max
Iout = 0% to 100%
Iout = 0% to 100%
±0.2
%
±0.5
%
±1.0
%
Ripple & Noise (20 MHz)
See Note 1
85 mV P - P
Output Power Protection
Transient Recovery Time, See Note 2
Transient Response Deviation
170
25% Load Step Change
250
±3.0
% I_OUT
µSec
%
Temperature Coefficient
±0.02
%/ºC
Output Short Circuit Protection
General
Continuous (Autorecovery)
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage (Input/Output)
Isolation Voltage (Case/Input(output)
Isolation Resistance
Isolation Capacitance
3 Seconds
3 Seconds
500 VDC
100 kHz/1V
1,600
1,600
1,000
1500
VDC
M⍀
pF
Switching Frequency
EMI Characteristics
270
kHz
Parameter
Standard
Level
Radiated Emissions
EN 55022
Class A
Conducted Emissions, See Note 3
ESD
EN 55022
EN 61000-4-2
Class A
Criteria B
RS
EN 61000-4-3
Criteria A
EFT, See Note 4
Surge, See Note 4
CS, See Note 4
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
Criteria B
Criteria B
Criteria A
PFMF
EN 61000-4-8
Criteria A
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40
+60
ºC
Operating Temperature Range
Case
+105
ºC
Storage Temperature Range
Cooling
-55
Free Air Convection
+125
ºC
Humidity
RH, Non-condensing
95
%
Physical
Case Size
1.25 x 0.80 x 0.40 Inches (31.8 x 20.3 x 10.2 mm)
Case Material
Metal with Non-Conductive Base (UL94V-0)
Weight
0.62 Oz (18g)
Reliability Specifications
Parameter
Conditions
Min. Typ. Max. Units
MTBF
MIL HDBK 217F, 25ºC, Gnd Benign 1.0
MHours
Absolute Maximum Ratings
Parameter
Conditions
Min. Typ. Max. Units
Input Voltage Surge (1 Sec)
24 VDC Input -0.7
48 VDC Input -0.7
50.0
100.0
VDC
Lead Temperature
1.5 mm From Case For 10 Sec
260
ºC
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com