A100ERU Datasheet, PDF (1/2 Pages) MicroPower Direct, LLC – Single & Dual Output, 1.5W Ultra-Wide Input Range DC/DC Converters

A100ERU _Series
Single & Dual Output, 1.5W
Ultra-Wide Input Range
DC/DC Converters
Electrical Specifications
Specifications typical @ +25°C, nominal input voltage & rated output current, unless otherwise noted. Specifications subject to change without notice.
Key Features:
Input
Parameter
Conditions
Min. Typ. Max. Units
• 1.5W Output Power
• 4:1 Input Voltage Range
Input Voltage Range (See Note 1)
24 VDC Input 9.0 24.0 36.0
48 VDC Input 18.0 48.0 72.0
VDC
• 1,500 VDC Isolation
Input Filter
Capacitors
• -40ºC to +85ºC Temp Range _{Short Circuit Input Power}
1,000
mW
• Compact DIP Case
Output
• Single & Dual Outputs
Parameter
Conditions
Min. Typ. Max. Units
• 1.0 MH MTBF
Output Voltage Accuracy
±1.0 ±3.0
%
• Industry Standard Pin-Out Output Voltage Balance
Dual Output , Balanced Loads
±3.0
%
• Low, Low Cost!
Line Regulation
Vin = Min to Max
±0.2 ±0.75
%
Load Regulation
Iout = 10% to 100%
±0.5 ±2.0
%
Noise (20 Hz - 300 kHz)
See Note 2
50 100 mV P - P
Ripple (DC - 20 MHz)
50 mV P - P
Output Power Protection
120
%
Temperature Coefficient
±0.03 %/ºC
Output Short Circuit
Continuous (Autorecovery)
General
Parameter
Conditions
Min. Typ. Max. Units
Isolation Voltage
60 Seconds 1,500
VDC
Isolation Resistance
500 VDC 1,000
M⍀
Isolation Capacitance
100
pF
Switching Frequency
550
kHz
Environmental
Parameter
Conditions
Min. Typ. Max. Units
Operating Temperature Range
Ambient -40
+85
ºC
Storage Temperature Range
-50
+125
ºC
Cooling
Free Air Convection
Humidity
RH, Non-condensing
95
%
Physical
Case Size (See Note 3)
1.25 x 0.80 x 0.37 Inches (31.8 x 20.3 x 9.5 mm)
MicroPower Direct
292 Page Street
Suite D
Stoughton, MA 02072
USA
Case Material (See Note 3)
Weight
Reliability Specifications
Parameter
MTBF
Non-Conductive Black Plastic (UL94V-0)
0.52 Oz (15g)
Conditions
Min. Typ. Max.
MIL HDBK 217F, 25ºC, Gnd Benign 1.0
Units
MHours
T: [phone]
F: [phone]
E: [e-mail]
W: www.micropowerdirect.com
Absolute Maximum Ratings
Parameter
Input Voltage Surge (1 Sec)
Conditions
24 VDC Input
48 VDC Input
Min.
-0.7
-0.7
Typ. Max.
50.0
100.0
Units
VDC
Lead Temperature
1.5 mm From Case For 10 Sec
300
ºC
Internal Power Dissipation
All Models
1,500
mW
Caution: Exceeding Absolute Maximum Ratings may damage the module. These are not continuous operating ratings.
www.micropowerdirect.com